(800) 853-2651
SHOP NOW

Recent content by kabat

Yesterday's Tractor Forums
  1. K

    who has mounted a camera on a loader?

    Yes it does. I don't even notice them anymore. I use the camera for everything. It has 3 wires. A black is ground, a red for hot, and green goes to reverse in a car. I hooked red and green together in a plug for cigarette lighter. You will love it. Only thing is it has a button to reverse...
  2. K

    who has mounted a camera on a loader?

    I think I got a picture
  3. K

    who has mounted a camera on a loader?

    Walmart.com. 60 foot cord. I mounted my camera on a strong magnet. Move it where I need it. Easy to put a cigarette lighter plug on it. I use it everywhere. Works great turning a tractor and baler left off the highway.
  4. K

    WD 45 live hydraulic pump

    My dad once had a D17 with a power steering pump set up like that
  5. K

    Trying to mount 3pt on WD

    I welded a piece of heavy angle with pins welded to it across the drawbar. There is a hole mid way between the bell and the bail I put a bolt as a safety
  6. K

    Looking for Allis 190XT parts tractor

    Northside salvage. Red Bud Illinois. Specialize in AC
  7. K

    Power Steering?

    I have seen a set up off a combine put on a tractor. It takes some calculating, but not real hard to do. Use the whole complete system, steering wheel to the cylinder on the tie rods
  8. K

    Tractor Salvage Yard

    Cooks tractor in Germantown il
  9. K

    Shifter boot came loose on D17

    Twist and pull up will get the knob off. It just pushes on. The boot, push down and twist. Wouldn't be a bad idea to replace the boot especially.
  10. K

    Win energy lineman killed

    I work as a construction lineman. You definitely have to keep your head in the game. My wife used to ask me, did you think about me today? I would say, no. I was thinking about 12000 volts in my hand. There is so much that can go wrong. If any safety procedures are over looked, well not...
  11. K

    High School Auto shop Restoring 1954 WD 45

    Carlyle Illinois Ag classes do the same thing. You might Google them and ask how it works.
  12. K

    WD-45 Voltage Regulator placement

    Get a big hose clamp or two, drill small holes in it, grind the bolt heads flat, slip the clamps around the generator and bolt the regulator to it. Make sure the reg is grounded good, may have to run a separate ground wire to everything.
  13. K

    Allis Chalmers Salvage Yards

    North side salvage. Red Bud Illinois.
  14. K

    1000 to 540 rpm PTO

    A lot of pto equipment has where you can rotate the gearbox from 540 to 1000 check your manual or call a dealer
  15. K

    1940 WC Gas Tank

    I rinsed mine good with water. Put 5 gallons water and a 6 foot chain in it. Strap it to a tractor wheel and drive around. Pull the chain out rinse tank until it runs clear. Set it in the sun to dry out put it on and fill it up
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top