(800) 853-2651
SHOP NOW

Recent content by Keel74

Yesterday's Tractor Forums
  1. K

    1020 throttle

    I can't see all of the picture. Can you send the picture again but not quite as expanded so I can see all of it? I think that's where my problem is. As you move the throttle, the lever on the pump moves but it doesn't increase motor speed until you get about 2/3 of the way through the...
  2. K

    1020 throttle

    Spring is still good. Next option?
  3. K

    1020 throttle

    My 1020 early model diesel will barely run at full throttle. If I reach down on the left side and pull the throttle by hand where it goes into the injector pump, it speeds right up just fine. It was working fine earlier today. I don't see anything broken on the throttle linkage and it...
  4. K

    37 loader SCV

    Does your loader have single acting cylinders to raise and lower the bucket? Mine does and this is what I saw on the surplus center description. Wolverine by Prince. Compact two spool joystick valve for operating double acting cylinders. Ideal for use on front end loaders on small to medium...
  5. K

    37 loader SCV

    Would that mean a closed center loader control valve would not work for me, with the power steering pump being open centered?
  6. K

    37 loader SCV

    Thanks for the tips Jim. I do need to do a full hydraulic system evaluation instead of just throwing parts at it. I was referring to the control valve on the loader frame. It's currently a 2 handle valve and I'd rather have a joystick style if I'm going to replace it anyway.
  7. K

    37 loader SCV

    Does anyone have a suggestion for a replacement SCV joytstick for a 37 Front End Loader on an early 1020JD? I've noticed that my loader gets weak when I have the clutch pedal pressed in(disengaged). I changed over to the ported filter cover recently and I saw improvement but I'm seeing this...
  8. K

    1020 diesel fuel filter change

    My tractor only has 1 filter. It has a plastic drain screw on thebottom. Is the retaining screw up inside the glass bowl on the bottom of the filter? Is it a screw or bolt?
  9. K

    1020 diesel fuel filter change

    How do I remove the fuel filter from my 1020. It has a plastic water drain plug in the bottom. It has a glass bottom about a 1/2" thick that fits on the bottom of the filter.
  10. K

    1020 hydraulic problem

    Do you mean something clogging it or a valve of some kind restricting it? Should I look for a Deere valve that would have been factory installed?
  11. K

    1020 hydraulic problem

    You wouldn't have the part number for that flow control valve, would you?
  12. K

    1020 hydraulic problem

    Wow,thanks man. Had no idea they even existed. I'll do that.
  13. K

    1020 hydraulic problem

    Thanks for the info. I put the gasket in with grease today. Made 100% sure it was in properly. Secured filter housing against the gasket and it still blew out the gasket when the loader returned to the ground. I attached a picture of how I have it plumbed. I think it's too much...
  14. K

    1020 hydraulic problem

    I'm not familiar with all the hydraulic terminology of open and closed center. Is this in some way contributing to my issue or were you just offering the information? Either way I appreciate it, I've got lots to learn about hydraulics. Thanks again for all your help. Hope you have a...
  15. K

    1020 hydraulic problem

    Serial number is below the 45,000 number break.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top