(800) 853-2651
SHOP NOW

Recent content by keileenj

Yesterday's Tractor Forums
  1. K

    How to rewire fuel pump when removing external resistor

    used red MN: Re" "the spaghetti": The purpose of the two wires with the blue connectors that come of the front of the resistor and disappear out of the top of the photo are 1) a black wire that runs to the push button switch 2) another black wire that is cut off at the edge of the harness up...
  2. K

    How to rewire fuel pump when removing external resistor

    I'm also wondering if maybe the resistor itself was bad. I didn't try replacing that, but I replaced the external resisted coil twice. The original problem was that the tractor would run for 20-30 minutes while mowing, then it would putter and stop. Only after being completely cool would it...
  3. K

    How to rewire fuel pump when removing external resistor

    Hi Tractor Guru, Thanks for posting that wiring diagram. It's much clearer than the one in my owner's manual. Would you be able to post the right side close-up of the diagram, too? (the full diagram is a bit blurry & I can't see where the black wire from the fuel pump connects to). I was...
  4. K

    How to rewire fuel pump when removing external resistor

    JohnT= Are you saying to take the fuel pump wire (currently on the ballast) and connect it directly to the coil--to the same post on the coil that the ignition wire is connected to?
  5. K

    How to rewire fuel pump when removing external resistor

    Thanks for the response! More info: In the meantime, I connected a jump wire from the +post of the coil (where the ignition wire is connected) to the far side of the ceramic resistor where the fuel pump is connectd to give the fuel pump more power. With this setup, the tractor now...
  6. K

    How to rewire fuel pump when removing external resistor

    My dad gifted me a 1967 IH 424 gasoline engine tractor. I'm a novice to engine repair of any kind, so slowly learning and plodding through all kinds of advice forums. I'm hoping someone can help with the following: Per the recommendation of two antique tractor repair technicians, I've...
  7. K

    How to rewire fuel pump when removing external resistor

    My dad gifted me a 1967 IH 424 gasoline engine tractor. I'm a novice to engine repair of any kind, so slowly learning and plodding through all kinds of advice forums. I'm hoping someone can help with the following: Per the recommendation of two antique tractor repair technicians, I've...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top