Recent content by Keiths4???

  1. K

    4610o Ford loafer and tear lift slooow.

    So no no dip stick so will use the bolt (unpainted) for checking level. Pulling a quick sample from the drain plug on the bottom. Also will have to drain and due the transmission that looks milky. For the power steering??? Use regular power steering fluid or same as trans or rear end...
  2. K

    4610o Ford loafer and tear lift slooow.

    Great Ill get the filter and drain the system. I know it looks milky my first thought was where was water getting in well new gear shift boots are on the way. I do keep it under cover but It was out stuck in a mud hole for a few weeks in the rain sure thats what started this conundrum... Dont...
  3. K

    4610o Ford loafer and tear lift slooow.

    Thanks guess I overlooked it. Property Best to drain the system. Whats the correct steps? Warm up, all cylinders retracted, and drain . What are all the places I should drain from? Is the pump on the side of the engine only power steering? If I remember correctly you gave me advice on...
  4. K

    4610o Ford loafer and tear lift slooow.

    Help needed on hydraulic issue Have a 1988 4610o Ford the hydraulics on the front end loader and rear lift are slow. Moving the control valve adjuster on right side does nothing. Fluid level is good Looking for advice ...do I need to rebuild the pump ? Is there a filter I dont see ? This...
  5. K

    4610o 1988 hydraulic pump help

    Have a 1988 4610o Ford the hydraulics on the front end loader and rear lift are slow. Moving the control valve adjuster on right side does nothing. Looking for advice ...do I need to rebuild the pump ? Is there a filter I dont see ? This old girl wasnt taken care of. I rebuilt the front end...
  6. K

    What Ford do I have

    Hope you had a great Christmas and New Years. I finally got the front end rebuilt it was a mess. The lower thrust bearings all that was left was part of the race and housing I liked to have never gotten them out. The left side I tried everything to get the half moon key out, heating...
  7. K

    Starter Switch question

    I have the switch ordered. I received the new front spindle kit for the 4610. In preparation have all of the drag link off and tie rod assembly off and the new ones already assembled and ready to go back on. What is the best way to remove the upper and lower spindle bushings? Can you...
  8. K

    Starter Switch question

  9. K

    Starter Switch question

    Thanks, I wasn t sure if I would short something out I was thinking of disconnecting that lead and trying that, but then thought it may be sending a signal to a make relay. I give you an update The boss has me working on a atv for a law enforcement atv training class... have to go through the...
  10. K

    Starter Switch question

    Been off for a few days then preparing for the big freeze here. But finally got to go look at it a little. Well it has the electric solenoid I showed only 10.33 volts that was odd. I hit the key and it started ran 30 minutes. Tried restarting same as before would not stay running. Going to try...
  11. K

    Starter Switch question

    At work we have a 5610 , replaced the neutral safety switch last month. Been starting fine. Now it fires right up but when I release the key it dies. Checked fuel and such, thinking it s just the switch is there a way I can check the switch out or am I looking at the wrong issue? I can use a...
  12. K

    What Ford do I have

    Thanks on some of your history I understand it feels less like work when it s your own place, our old place kinda calls for me I feel at pease there. You have been so much help to me in figuring out what tractor I have. Well hopefully I have figured out how to get the correct parts ordered...
  13. K

    What Ford do I have

    Wow that is great, thanks for the education and all of the help deciphering this old girl. So by having the nose down I would think that it would pull better. The low profile in an orchard would be a plus for clearance. But I guess the ROPS and top cover were added for sun shade if just...
  14. K

    What Ford do I have

    Yes you can see why a novice would be so confused. I contacted a New Holland dealer this morning and they are working me up a parts list. They too were surprised when I sent photos and numbers. I think they thought I was pulling their leg until they saw the pictures. I ll keep everyone posted...
  15. K

    What Ford do I have

    What parts & service manuals do you recommend ??
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top