(800) 853-2651
SHOP NOW

Recent content by KENWORTH

Yesterday's Tractor Forums
  1. K

    john deere 45 loader

    have a 45 loader mounted on a 620. it has a small dozer blade on the front. does anyone know if that can be angled some way? thank you/bruce
  2. K

    55 95 combines

    hello all. can anybody swag the model year of a 95 jd combine, type #95 serial #7605, and a 55 combine 55-73893 THANKS FOR YOUR HELP!!!!
  3. K

    john deere 95

    clutch will not engage to allow smooth shifting of transmission gears. need to force in & out of gear to move combine. stepping on the clutch pedal does nothing,will not stop machine when in gear.
  4. K

    john deere 95

    hi guys. need some help again. i have a 1959 john deere 95 combine w/16' grain table. it is and was shedded its entire life. it is in excellant shape for its age. i was cutting wheat with it and the wheel drive transmission clutch failed. it is a variable speed machine. it worked fine, previous...
  5. K

    jd 730d flywheel

    hello all and thank you for the help. i have a couple more questions that i need some advice on. i have positioned the flywheel up farther on the crankshaft. i think i have it where it needs to be, i still have aprox. 1/4"of the splined taperlock exposed (is not flush with the end of the...
  6. K

    730d fly wheel

    ok, i have convinced the flywheel to move into what i think is the correct position. the wedge is NOT flush with the end of the crank shaft. it protrudes aprox. 1/4".i still need to tighten the nut. it seems tight, but there is about 1/8" air gap between the nut and the face of the fly wheel...
  7. K

    730d fly wheel

    hi all. i had flywheel problems a couple of years ago, on my 730d (main engine) I replaced it with a taperlock version, with a large square nut. i heard something ticking in the flywheel cover. i removed the flywheel cover, only to discover that the flywheel assy. had moved out on the cranksahft...
  8. K

    730d transfer diesel pump

    hi all, need some good advice. my transfer pump seems to weep fuel. i install a new mounting gskt and it seemed to run better and the fuel leakage stopped for a while. it now still seems to weep fuel, but not as much. i think it runs not as well also. can these transfer pumps be rebuilt or...
  9. K

    620 float seat knurled pin removal

    hi. does anybody have a good method to remove the knurled pins in my float ride seat. i recently purchased a rebuild kit for it. hammer & punch will not do it. special tools? thanking you in advanced.bruce
  10. K

    620 rockershaft arms

    hello. i have a row crop 620. the 3 point hitch rockershaft arms arm stuck in the raised postion. i have pull the battery box/seat and the large cover under that. the linkage is all connected and everything moves when the 3 point control is moved forwards and back. i believe the valve that...
  11. K

    620 rockershaft

    hi guys. think i may have figured out my problem on my 620. now i need a solution. the rocker shaft has not been used for quite some time. i went to install a 3 point hitch on it, as it did not come with one. i cycled it a few times and it seemed to work fine, but then the engine started to pull...
  12. K

    620 jd hydraulics

    hi guys. i took off the seat/batt.box and took the hydro. cast cover off. pumped the oil out. the linkage all appears to be ok. everything moves and seems to be fine. the piston that goes up and down, that controls the rockershaft is all the way down and appears to be stuck. how free should this...
  13. K

    620 jd hydraulics

    hi, i need some help figuring out what happened to my hydraulics on my 620 row crop. i have a #45 j d loader on it. works great. i added a 3 point set up. i started moving the three point lever back and forth, to lower and raise the arms. the engine pulled down hard. every time i tried to lower...
  14. K

    tractor chain installation

    need some advice on installing a set of rear tractor tire chains on a 620 jd. 13.6-38's these are used and the previous owner said they fit on a 630 jd. any tips or secrects that may aid me in the installation process. thanking you in advance. bruce
  15. K

    xb wico dist. parts

    where can someone purchase xb wico dist. parts? i need a coil and a cap & rotor. can not seem to find out much info. thanks for your help
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top