-
K
Ford 641 3 point always raising
Mine sat for 4 years out in the weather, and had no lift. I just finished the hydraulic rebuild last weekend. I removed the lift cover cleaned everything, replaced o-rings on the lift cylinder and accessory plate, adjusted the linkages, but didnt put a new o-ring on the unloading valve or... -
K
trying to identify what may be missing here
Looks like it is missing the hydraulic lift cover. There are several o-rings that go between it and the tractor as well.- kessol
- Post #1
- Forum: Ford 9N, 2N & 8N
-
K
Transmission to center housing torque
Thanks for all the input everyone. I think I got it figured out. Once all the bolts are installed, you have four bolts heads and six nuts on the transmission side. So if you torqued the bolts to 50-60 and the nuts to 40-50, it would be a similar pattern as the 2000 series. Shop manual... -
K
Transmission to center housing torque
I m confused. If I install a bolt and put the nut on the other end, and torque the bolt to 60 lbs. Would the corresponding nut not also have 60 lbs of torque? I know that correct bolt tension is what holds the 2 sides together. I m just trying to wrap my head around it. -
K
Transmission to center housing torque
I have rebuilt the transmission on my 641, and I m ready to reinstall it on the center housing. I was reading the shop manual and it states: "Torque the nuts to 40-50; the bolts to 60-70 ft. lbs." Does this mean I torque the nuts first, then the bolts? -
K
Not a good start to the weekend...
Found it. There are very proud of it. :cry: -
K
Not a good start to the weekend...
I found where 310087 goes on the PTO shaft in the rear, so different part. Back to searching. -
K
Not a good start to the weekend...
The part with the arrow pointing to it is stuck. Tried heat, bearing puller, etc. My parts catalog says it is a "SLEEVE, Countershaft Oil Ge" NAA-77087-A. I cannot find a replacement part with this number. I did find part number 310087 "PTO Shaft Sleeve", and it looks like the same part... -
K
Not a good start to the weekend...
The rest looks okay. Replace the bearing and races, and put it all back together. -
K
Not a good start to the weekend...
Picked up the transmission housing today, now just have to split the tractor and get it all swapped out. -
K
Took a little trip for parts.
Not yet, I m planning on driving up to get it on Friday.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy