(800) 853-2651
SHOP NOW

Recent content by kevinstuff

Yesterday's Tractor Forums
  1. K

    Problems starting a Perkins an AD203 on a Massey Ferguson 30.

    May have hydraulic remote on ? white smoke ? could be water in fuel , My 530 Case did same , fuel cap stolen ,
  2. K

    Brake line is in.... bleeder screw is screwed....

    You will waste time trying ? remove wherl, dtum , springs , hold downs , cups ? spring from wheel cylinder , unbolt wheel cylinder from backing plate , use 6 point wrench on brake line and a long bar through eheel cylinder , hold wrench steady , using long bar to break free brake line and...
  3. K

    What solution to use for cleaning shop rags

    Fabuloso cuts grease like crazy
  4. K

    case 444 trans fluid

    yes very common , Shell rotella for mine 15w 40w
  5. K

    Shop Wiring

    Unless your runs are over feet , then 10-2 wg is a better choice , if less than 50 feet 12-2 wg is fine . instead of the added expence If your length of run is over 50 feet than the 10-2 wg is fine , less than 50 feet 12-2 wg is ok , have you looked into BX armored cable ? no need for conduit...
  6. K

    Case J44 mower deck

    This message is a reply to an archived post by 550Doug on June 08, 2023 at 17:31:10. The original subject was Case J44 mower deck. I would suggest to use a slide hammer to pull the spindles , just bolt the puller yoke to the flat part that holds the blade , will need washers to get above weld...
  7. K

    Electrkical challenge

    Try cranking it over in the darkness ,you should get some kind of light show, if wires leaking ,bad cap ect
  8. K

    New to me 446 Case

    Look close at wires around engine , and headlight The 3 wires coming out of the bottom of Left hand fan shroud , these are the leads to the alternator , inspect them closely .When my 446 freewheels , I push the Lift Handel forward which is down for attachments So depends what kind of attachment...
  9. K

    Sanding Garden Tool Handles

    Well I sanded them until smooth , then I used gorilla glue thinned out , and used it like stain , a couple coats to fill the larger gaps
  10. K

    How to remove rim rust stains ???

    If your rims are aluminum, coat with petroleum jelly (Vaseline)
  11. K

    Re: Odd Case 530ck hydraulic overflow

    I have 530D And mine does the same , the lift cylinder for 3 point is leaking , Overflowing the rear differential always having to drain it fill the trans
  12. K

    Cub head stuck

    When you reassemble the head bolts and studs do not ever use grease , as almost all will break down and corrode , leaving you the same damage your dealing with now . Use petroleum jelly , it is inert , and will not corrode Or cause rust , I am sure locktite makes a product for for sealing...
  13. K

    Real or fake? Starrett squares

    the small square on top is a Browne & Sharpe again the lock screw with the small knurled post sticking out is how all Brown & Sharpe look, the small Starrett have that sorta flat lock screw. Starrett also made a very large combo square , dont see them very often
  14. K

    Real or fake? Starrett squares

    The starrett with checkering in web are quite old , most likely cast , the big one is hardened starrett the lock screw gives it away , some are marked hardened along the edge of the long side ,
  15. K

    Case GT mower decks.

    The newer ingersoll have right hand discharge , The newer deck rotates the opposite direction due to motors The motor installed 180 degree . So the older left hand decks work with the belt clutch Mounted on flywheel end . Which faced the front of the tractor. And the newer ones work off the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top