-
K
Rusty Manifold Bolts
I want to switch the horizontal exhaust on my JD 1010 to a vertical stack but the bolts look terribly rusty. Should I attempt removing them or just live with the horizontal exhaust?- kidd131
- Thread
- Replies: 3
- Forum: John Deere
-
K
8N water pump
not sure yet didnt have a chance to work on it....I might try to look at it later today after work...- kidd131
- Post #1
- Forum: Ford 9N, 2N & 8N
-
K
8N water pump
the old nuts came off pretty easy and they didn't take a lot of force before I figured they were just spinning and not tightening down.- kidd131
- Post #1
- Forum: Ford 9N, 2N & 8N
-
K
8N water pump
So long story short my old water pump was squealing on my 51 8N so yesterday took the old one off and replaced with rebuilt one. Only problem is when I put the new one on I think I over tightened it and the studs are spinning freely in the block and will not tighten down enough to prevent...- kidd131
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy