(800) 853-2651
SHOP NOW

Recent content by kinglouie

Yesterday's Tractor Forums
  1. K

    JD 3010 Hot Wire to Turn Engine Without Key

    Hi Jim. Well I finally saw where the leak was. It was a torn o-ring on one of the pump fittings but the way the oil was shooting out it was pretty hidden and it was shooting upward do it was pretty deceiving and seemed like the oil cooler was the issue. I finally got it all stitched up again...
  2. K

    If ya cant beat em join em?

    Yeah insurance companies deserve no sympathy.
  3. K

    If ya cant beat em join em?

    What happened to the insurance money?
  4. K

    JD 3010 Hot Wire to Turn Engine Without Key

    Good morning and hello again, you've been a good help multiple times in the past so thanks a million. This is great information. I'm going to give this a try this morning. I hope I remember to tell you how it goes but if I forget I'd just like to thank you for taking some time to help me.
  5. K

    JD 3010 Hot Wire to Turn Engine Without Key

    Hey thanks. Would you have any idea which terminals I should clamp the red and black to?
  6. K

    JD 3010 Hot Wire to Turn Engine Without Key

    I have a 3010 with a hydraulic fluid leak somewhere up by the cooler / radiator but it won't leak unless the engine is turning. I have nobody to help me and turn the key so I was trying to figure out a way to turn the engine over using wires from the starter / solenoid. I'd prefer to use...
  7. K

    Old Post Hole Auger Slip Clutch Tightening or Modifying

    Oh yeah, I'd also like to hear what you think about the bolt for a shear bolt. Thanks.
  8. K

    Old Post Hole Auger Slip Clutch Tightening or Modifying

    Hi and thanks for the reply. Any idea what that friction material is or if a guy could still get any, or a substitute?
  9. K

    Old Post Hole Auger Slip Clutch Tightening or Modifying

    I've got an old post hole auger and the slip clutch is slipping too easily. There are lock nuts that I can't separate though. The nuts are about 1 1/2" and I don't have a flat wrench that big and a pipe wrench is too wide to fit on that inside nut but I've gotten a crescent wrench on it and...
  10. K

    Any tricks on making a temporary gas tank

    Do you need to use any sealant or glue?
  11. K

    Any tricks on making a temporary gas tank

    This comment could have been from a best-selling novel.
  12. K

    Any tricks on making a temporary gas tank

    Ha ha... this is by far the best and most correct post.
  13. K

    Hydraulic Line on 3010 Leaking

    Hey great there's a Napa right close. Great info thanks for replying. Have a great night?
  14. K

    Hydraulic Line on 3010 Leaking

    Thanks a lot for the information. I will do as you suggested. Have a great evening!
  15. K

    Hydraulic Line on 3010 Leaking

    Hi guys. I have a JD 3010 that got a hole about 3/16" around worn in it and it's now leaking. It goes from the part of the tractor below the brake pedals and a little further back to the bottom of the hydraulic pump in the front of the tractor. The oil that leaks out of the hole, that's...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top