(800) 853-2651
SHOP NOW

Recent content by kito 169

Yesterday's Tractor Forums
  1. K

    o/t guns safes or safes in general

    I am looking at gun safes and also those for home use. I have a question that I hope someone can answer for me concerning the fire ratings. If a safe has a fire rating of 1200 deg for 30 minutes, how much damage will the contents suffer in 1 hour? what I'm really asking is it worth the extra...
  2. K

    winch for car trailer

    I only buy Warn winches. Look on their website, as they have refurbished ones reasonably priced
  3. K

    Office pay vs shop pay?

    The way I see it is, if you make the big money you are going to earn it one way or another. Either putting in the hours or putting out the muscle whether you are management or not.
  4. K

    I will never do that again... Rant...

    If everything went perfectly, life would be soooooooo boring.
  5. K

    OT Home school

    Several of my relatives are teachers in the public schools. They all say that the more the parents are involved with the students schooling, both at home and at school, the better the student does. I believe from those comments that parental involvement in the childs life makes a big difference...
  6. K

    Do you wear gloves doing mechanic work?

    If you can find them pilots gloves are great. In the late 1960's when I was in the Air Force, we had to load flares for nighttime gun ship practice. This required inserting 1/8" x 1/2" pin into a hole to secure the firing lanyard. In the winter you could not use regular gloves so they issued us...
  7. K

    OT septic antifreeze

    I have used rock salt in the traps for years with no noticeable adverse affects. Just two or three rocks is all it takes.
  8. K

    3 point hitch does not stay level

    Tx Jim hit the nail on the head. Those N model fords were terrible about not staying set. If you don't have a rooster comb, do you have an overunning clutch on it? this is put on the pto and the bush hog drive shaft attached to it so the bush hog doesn't keep driving the tractor after the clutch...
  9. K

    smallest wire wheel

    Are you using the stainless steel brushes? They did that for me too. I have used the plain steel brushes for years with no problems.
  10. K

    just got back from PA

    Larry, it was especially refreshing to see your posts today. I had been reading some other forums where folks were arguing about different things. Then amongst all of this negativity there was your music and pictures. Thanks for the uplift. Rick
  11. K

    clickable video of the piano

    I really enjoyed the video. Keep 'em comin'.
  12. K

    Pole saws

    I was in the same boat you are. I needed a pole saw and a Stihl wAs really expensive. I had a Stihl string trimmer already. I bit the bullet and got the $600 Stihl extendable pole saw and am really glad that I did now. It is so versatile. I had to to sell a few more things to get it but am...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top