Recent content by Kuch1982

  1. K

    706 Starting issues

    I did thanks. I went and cleaned as much as I could. It was pretty clean already, but did it again to make sure. Still nothing, but will keep trying
  2. K

    706 Starting issues

    Ill give it a shot! Thanks!
  3. K

    706 Starting issues

    Ill give it a shot! Thanks!
  4. K

    706 Starting issues

    Well I appreciate the advice. Ill just start chasing wires until I can find something. I suspect there is an old cracked wire somewhere.
  5. K

    706 Starting issues

    Thanks for the advice. When I get a minute, Im going to pull the wires off the terminals and see if I can jump with a cleaner connection. I assume one of the wires goes to the 's' terminal directly, where does the other go? Ground?
  6. K

    706 Starting issues

    Uograded to 12 volt and full voltage. I do have power at the switch terminal, So Im boggled on why nothing happens when I jump the 2 terminals on the switch
  7. K

    706 Starting issues

    Uograded to 12 volt and full voltage. I do have power at the switch terminal, So Im boggled on why nothing happens when I jump the 2 terminals on the switch
  8. K

    706 Starting issues

    Ok...stupid me...I was on the wrong starter terminals. (Its been a long week) I got it to fire! Thank you!!! So I guess that leads me back to the switch...but not sure how it wont turn over when I jump the wires there. Just nothing
  9. K

    706 Starting issues

    Ok...stupid me...I was on the wrong starter terminals. (Its been a long week) I got it to fire! Thank you!!! So I guess that leads me back to the switch...but not sure how it wont turn over when I jump the wires there. Just nothing
  10. K

    706 Starting issues

    Early serial # 706 diesel. For the last little while trying the push button start, it clunks then nothing immediatly after. A few pushes and it will finally turnover. However, tonight it did one clunk, and nothing again. Pushing the button multiple times and not a peep. Figured it was the...
  11. K

    Gear selector issue

    IH 706, seems the shifter isn't lined up with the gear markings on the console. Ex: trying to put in reverse, you basically have to slam it down to the bottom of console, sometimes it won't even find reverse. Is there a linkage adjustment somewhere? Shifts fine otherwise, but seems it's not...
  12. K

    IH 706 D282

    Thank you for all the help. Ill do some tinkering around and see what I can come up with
  13. K

    IH 706 D282

    My fat fingers typing...1500 rpm is all it gets up to.
  14. K

    IH 706 D282

    None taken. Yes, fuel comes out
  15. K

    IH 706 D282

    No change with cover off or on
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top