(800) 853-2651
SHOP NOW

Recent content by larry 5559

Yesterday's Tractor Forums
  1. L

    rocker arm shaft wear

    A 430,a little loader work,6 ft. finishmower,a couple of yearly plow days
  2. L

    rocker arm shaft wear

    Is .007 to much wear on a rocker arm shaft where should be replaced? service manuel just states it should replaced if it shows excessive wear?
  3. L

    430 HYDRAULIC PUMP

    I;m overhauling my 430 and plan on putting a 35 loader on it.When I took apart the hydraulic pump there was wear on the center section of the pump where the gears lay flat against it,there's also wear on the center section where the end of the pump gears have rubbed against the outside edge of...
  4. L

    wayne in tn.

    Does anyone know what happened to wayne in tn. the man sure did know alot about dubuques.
  5. L

    IH 340

    I been considering buying a 340 utility with IH loader, both good shape but does need some mechaniclly,are parts still available for these tractors?Steering mostly.
  6. L

    340 u with McCormick loader

    IH dealer has a 1958 340 u with loader for sale.Older repaint,reverser,fenders,remote hydraulics,3pt.fast hitch,McCormick tubular loader(no welds),2 buckets(a small one and a 50-60in.)and good sheet metal,no noise in trans.Tires 50%(rears)with a 2in. chuck of rubber gone on the side wall,rusty...
  7. L

    wiring harnesses

    I need a new wiring harness for my 430,who makes a better harness,Agri-services or Brillman Co.
  8. L

    JD 35 loader stands

    Still looking for a set of JD 35 loader stands,36 and 46 are also the same.call 517-442-8064.Thanks.
  9. L

    Looking for JD 35 loader stands

    DAVE, COULD YOU PLEASE SEND ME SOME PICTURES AND MEASURMENTS OF YOUR LOADER STANDS. THANKS LARRY [email protected]
  10. L

    Looking for JD 35 loader stands

    COULD YOU SEND ME PICTURES & MEASUMENTS, WHERE DO YOU LIVE, WHERE I MIGHT BE ABLE TO PICK THEM UP ?? THANKS LARRY
  11. L

    Looking for JD 35 loader stands

    please send me the pictures,& measurments, of the jd loader stands ! thanks larry
  12. L

    Looking for JD 35 loader stands

    thanks for responding, i live in adrian, michigan, e-mail me, or call phone # is 517-442-8064
  13. L

    Looking for JD 35 loader stands

    Looking for a set of loader stands for a 35 loader,stands from 36 and 46 are the same.
  14. L

    henry loader

    I"m thinking of buying a henry loader off a 40U,will this bolt up ok to my 40T with no problems. Thanks larry s.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top