-
LHey folks, I purchased an umbrella from this site. It’s made for the smaller ROPs vs the larger round ROPs that comes from this model...
-
-
L"I also store it in a shed with a door which will not all me to add too much more height." Looks like your ROPS is several inches taller...
-
LLarryBud replied to the thread Umbrella Options?.I’ll take a look. Thanks.
-
LThinking if it blew forward you would not smell it. For sure if you can go straight up it will get away. Worst case if the system...
-
LMy 1981 3600 has the ROPS with a round cross bar on the top. I believe this eliminates most of the umbrellas which attach to the ROPS...
-
LLarryBud replied to the thread 3600 Muffler / Exhaust Options.Pretty sure this is the case. The mod is well done except for the fume factor. I'm going to cut off the 90 and ad an extension that...
-
LThe way his exhaust curves up into the manifold a exhaust flapper isn’t necessary I’d cut the elbow off and try in like that, if it...
-
LLarryBud replied to the thread 3600 Muffler / Exhaust Options.Thanks for the replies. I'll do some homework and make a decision.
-
LI use a 3600 for Brush Hog / mowing work. I'll be converting 18 acres from pollinator habitat to pasture the next few years which will...
-
-
LLarryBud replied to the thread Ford 3600 - Tubes?.Closing out this thread. Thanks for the insights gents. Looks like I got away with a core replacement. 24 hrs later and still holding...
-
LLarryBud replied to the thread Ford 3600 - Tubes?.Thank you. I did replace the core with a " Slime " brand valve. The plastic nut has deteriorated. The soapy water test had a leak at...
-
LLarryBud replied to the thread Ford 3600 - Tubes?.Here’s a picture with the core removed. The fuzzy picture in the first post is from the other rear.
-
-
LThink I have tubes on the rear on my 1981 3600? I have a leaky valve. I replaced the core today and it stopped by I'm guessing this...
-
-
LLarryBud replied to the thread Ford 5000 cranks but doesnt start.Just went through this on my diesel. See the thread below. I might be your problem if you have fuel to the pump but not the lines...
-
LLarryBud replied to the thread 3600 Fuel?.Just closing out this thread. I worked both the shut off lever and the throttle lever vigorously while cranking the engine. One of...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy