Recent content by Lee Pichan

  1. L

    8N traction

    I have an 8N with "larger" rear tires that have chloride in them and have excellent traction when pulling my spring tooth drag. I recently bought another 8N with "smaller" rear tires that are probably standard size. They do not have chloride in them and when I used it for the first time...
  2. L

    alternator pulley replacement

    Used the 12 volt coil and left the 4.9 ohm resistor in the box, and it fired right up! Runs great. Thanks to everyone for all of the help!
  3. L

    alternator pulley replacement

    Dell, The original 6volt coil had a resistance of .7 ohms, and the 12 volt coil that came with the conversion kit has a resistance of 3 ohms. The original resistor in the tractor has a resistance of 1.0 ohms. The add on resistor in the kit is 4.9 ohms. So do I need the extra resistor? Thanks!
  4. L

    alternator pulley replacement

    So do I need to check the total resistance to decide if I need the extra resistor (the original resistor is on the tractor), or just add it? What should the total resistance be? thanks for all of the help!
  5. L

    alternator pulley replacement

    Kurt, Thanks! - I didn't notice the hex screw before. One more question. There was a 12volt coil in the kit along with a resistor. Do I need a total resistance of 3.3 ohms either with or without the resistor? thanks again!
  6. L

    alternator pulley replacement

    I have purchased a 12 volt conversion kit from Yesterday"s Tractor for my "48 8N (front mount distributor). Today I tore into the project and everything is going ok so far, except it looks like I need to change the pulley on the alternator in the kit. There is a extra pulley with a wider v...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top