(800) 853-2651
SHOP NOW

Recent content by Leonard Dacus

  1. L

    hydraulics 4010

    hydraulics seems to get air in system when not in use. Start up after sitting over night have to raise and lower the loader a few times to get it to operate smooth. any ideas what my problem is? any help appreciated.
  2. L

    4010 loader problem

    thanks for this abundant amount of help, makes me happy to just be a 82 year old American. again thanks Leonard
  3. L

    4010 loader problem

    question is there someone who has the recommended parts fittings and pipe foe this recommended set up, Your recommendation sounds good to me. Thanks Leonard.
  4. L

    4010 loader problem

    to answer a couple of the question, oil supply to valve by putting a tee right side where oil goes to 3 point hitch valve, return I replaced the nipple where fill port to put the oil in hyd. system, took original nipple out put in short nipple then tee with one half then short nipple came out...
  5. L

    4010 loader problem

    I have a 4010 JD WITH A jd48 loader, It was originally set up to operate with the dual remote on the tractor I have used it that way for many years. Over the years valves operated rough so I have installed a Cross valve Joy stick style. I am having trouble getting the air out system. I have run...
  6. L

    hydraulics 4010

    joy stick valve. closed center or open center.
  7. L

    hydraulics 4010

    I have a 4010 JD. with a old JD. no.48 loader now operates with the remote dual hydraulic. I would like to mount a joy stick hydraulic valve to give me better control when slow steady movement is needed.my knowlege of hydraulic systems is not very good so heres my question? with the valve in...
  8. L

    removing stub shaft rear wheel bolts on to. D-17

    I need some advise on removing stub shaft that rear wheel bolts on to. I have the wheel off remove cover off drive gear including cap, on inside bolt washer plus shims also snap ring that holds big gear in place, put stud bolt back in found short piece of pipe that fit snuggly over bolt head to...
  9. L

    brake problem D17 allis series 4 newer style same as 170 i

    I have a new problem on D-17 had problem getting the right seal for axel hope that is on track. now I have new problem, seal on stub shaft that the wheel bolts to show signs of seeping oil so I thought I would replace it while I have it blocked up. I pulled the cap off removed bolt with shims...
  10. L

    brake problem D17 allis series 4 newer style same as 170 i

    thanks for help, found lower pin had came out
  11. L

    brake problem D17 allis series 4 newer style same as 170 i

    something broken I have top cover off band on rear loose and flopping at bottom. question is can I pull axel before removing bands. help on correct procedure getting pins out to get bands off I have wheel off axel housing ready to pull so I stopped and started scratching my head in confusion any...
  12. L

    H John Deere Air cleaner screen

    need to replace screen in air cleaner on a H john Deere, Any one done this I could use any help if someone has done this. thank in advance LEONARD.
  13. L

    BRAKE PROBLEM

    need information with brake D-17 series 4 something happened petal goes all the way down does not apply any braking on right side, has been ok for years, just happened all at once. took a quick look block that rod screws into for adjusting is loose indicating something with lower brake has...
  14. L

    special thanks for the help

    4/2/17 I had a post asking for help repairing trip beam on my john deere moldboard plow ,just wanted to take a minute and express my appreciation for the helpful post, Special thanks to tyler-mo for the instruction sheets covering the whole trip beam assembly, Disassembled unit found broken...
  15. L

    F120 john deere mold board plow

    I have a F120 4 bottom John Deere breaking plow trip has starting tripping plowing up bermuda sod one beam has starting tripping when plowing no hanging on any solid objects .is there a way to increase pressure on trip load. any solutions to problem appreciated. Leonard D.
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top