Recent content by lkerr

  1. T

    1750 with loader

    I have a 1750 with loader plumbed into the remote hydraulics. The bucket cylinders bleed down a bit. I've rebuilt the cylinders. My fear is the remote valve is leaking by. Is this difficult to repair? Possibly just some o-rings or something more? Thanks, Darin
  2. D

    Another Stupid find.

    The more I work on the MH44 WF, the more stupid I feel for buying it. I found one of the wheel bearings was replaced with a ball bearing and the outer race was shimmed in with a power hacksaw blade. I think one of the spindles is bent too, gotta check that out.
  3. J

    David Brown 990A Steering

    I am looking for a reasonably priced hydrostatic steering system for my 990A, from the steering column to the ball joints. I currently have a broken "power-assist" set-up and everyone I have talked to recommends changing it over to the hydrostatic system. Most of the bigger salvage yards have...
  4. S

    Hung in gear

    I have a international 574 . My speed lever for rev. & forward is good. BUT my shift lever won't go in rev. And now after working with it, It won't go in neutral or forward. Please give me some serious help. Thanks
  5. W

    John Deere R Fender extentions

    Does anyone have a diagram or notes showing where the 4 spacers are used in mounting the extentions? The parts book shows 4 each but no picture. Thanks Wes
  6. J

    case 870 or 970 w/ ps newbie

    i have service manual and am reading about 70 series power shift rps34. when did case make ps with a parking gear ? do any of 70 series have diff lock ? are there major differences between 90 and 94 series ps ? i am always nervous buying gen 1 but they are so inexpensive. what is an avg estimate...
  7. F

    1755 Instrument Panel-Differences in serial #'s

    I have a 1755 that I am converting from cab to open station. I removed the cab and bought a floor platform set for it, but the outer platform pieces on each side wont bolt up properly to the tractor. My instrument panel is an entire welded assembly that was all the steering and brake valves in...
  8. T

    Ugh, red headed this way !

    Stay away from lima ohio , news says up 30000 people with be at the show.
  9. R

    M/F 202 PTO

    my brother"s 202 massey ferguson, after cutting grass for 10 or 15 minutes the PTO slows down and the tractor stops. disengage the pto and the tractor moves normally. Is this a clutch problem or possibly something bad in the the pto drive line? Removed the top plate over the pump and PTO, to...
  10. W

    Head gasket SW4

    In am doing out of frame overhaul on my SW4. I am increasing the engine from 3.5 to 3 9/16 bore. I have been told there are two different head gaskets. one for each bore. How do I know my suppler got me the right one? Thanks
  11. L

    Jacobsen Lawnmower Blade.

    I'm trying to locate a blade (# JA991189) for an old Jacobsen lawnmower. Any ideas who to contact? Thank you.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top