-
Martin Senour - napa 8010 synthetic enamel hardener
Says call store for availability, can not add it to a cart. I call local store says it is unable to get it. Going to try calling another store again today.- LStallbaumer2
- Post #4
- Forum: Restoration Processes
-
Martin Senour - napa 8010 synthetic enamel hardener
I'm struggling to find a source for napa 8010 synthetic enamel hardener. Talking with the local NAPA store and they tell me they can not get it anymore. It shows in inventory but they can't get it shipped. I don't understand why anyhow I'm looking for an alternative product. I have had 2...- LStallbaumer2
- Thread
- Replies: 4
- Forum: Restoration Processes
-
8 Speed Power shift knowledge needed
Fixed it thanks for the help It turned out to be the gasket between the cast portion of the power shift valve and the steel plate. The gasket had blew out between oil runs off of the passage that controls b1. I took the valve off the side of the trans and put air to the ports on the trans for...- LStallbaumer2
- Post #12
- Forum: John Deere
-
8 Speed Power shift knowledge needed
I appreciate the info. Just trying to wrap my head around what the inching clutch does the concept before I do all the pressure test. So what I have gained from this is that the inching clutch does. If i understand it correctly it cuts pressure to c1 and c2.. ---- C1 and c2 are used in 7th...- LStallbaumer2
- Post #7
- Forum: John Deere
-
8 Speed Power shift knowledge needed
So you are saying b1 is engaged in park- LStallbaumer2
- Post #5
- Forum: John Deere
-
8 Speed Power shift knowledge needed
The thing I don;t understand is that in park none of the clutch packs should be engaged correct. and the gauge on dash is on zero unless you rev it up. Start it up in park and it wont railse 3 point hardly at all. Press clutch in park and 3 point comes up normal and I have a loader on it and...- LStallbaumer2
- Post #4
- Forum: John Deere
-
8 Speed Power shift knowledge needed
I have read all the conversations on this site regarding the 8 speed power shift. Lots of great knowledge out here. .Doing extensive testing before I tear into this. Here is my question – On a 68 4020 When you press in the inching pedal/clutch what does that actually do— does that cut off all...- LStallbaumer2
- Thread
- Replies: 13
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy