Recent content by Ltmoeller

  1. L

    1946 2N won't start

    Ok,ran wire from hot side of bat. to nut on coil and it started right up. Tom
  2. L

    1946 2N won't start

    Bruce, I'm not understanding "@ bolts,the coil wire nut & it's off the tractor to check.Also how do I jump the resistor? Tom
  3. L

    1946 2N won't start

    I'll do some more checking and report back.Not sure how to check voltage on oem resister. Tom
  4. L

    1946 2N won't start

    No reading on the resister except on the 2 screws that attach it to back of dash.I replaced the damaged wire still no spark. Tom
  5. L

    1946 2N won't start

    It was running fine,now won't start.I noticed the wire going to the coil laying against the exhaust manifold burning the insulation.Im sure It shorted something out.Is there a short answer o what it would be or do I need to pull the distributor.12 volt conversion,nor sparta at the plugs. Thanks...
  6. L

    air pressure for painting

    It can be confusing,The gun your looking at is the best way to go,but they use a lot of air.You need high pressure at the gun but you will get low pressure at the nozzle.Again look on the specs on the gun for required cfm from compressor.To small of a compressor and you will make a couple of...
  7. L

    air pressure for painting

    The nozzle tip needs to be 4.0 for what your doing.The paint manufacture should have listing for air pressure.What many people don't know is air pressure at the gun not the tank.A 10 gallon tank will never supply enough air delivery for a hvlp gun.Also the paint gun should list the cfm output...
  8. L

    Wiring issue

    JMOR,not sure what your problem is.Here is the diagram I used,hope your happy.
  9. L

    Wiring issue

    Sorry JMOR,I used a wiring diagram from just 8n and it showed positive from starter to one side of the ammeter the other side to negative battery post.Well,that's wrong,for me anyway.So upon advice from this forum both sides of ammeter are hot that's the wire I changed. Tom
  10. L

    Wiring issue

    Put some gas to it fired right up and charging fine. Thanks everyone Tom
  11. L

    Wiring issue

    Ok,I did not know this,I'll put some gas to it in the morning and see if it starts. Thanks,Tom
  12. L

    Wiring issue

    I replaced the mechanical start switch, problem is it will turn over with the key on or off.What have I done?I picked a diagram and still an issue. Tom
  13. L

    Wiring issue

    Changed a couple of wires it now turns over.I have discovered I have no continuity at foot switch on motor side but I can jump it. Tom
  14. L

    Wiring issue

    Ok,I looked at the jmor diagram is my starter floor button not a solenoid?Do I need to use a solenoid also.Ive looked at several diagrams for the 46 2N so I'm confused witch one I need to use.I bought the tractor with no wiring so I'm starting from scratch with 12 V conversion. Tom
  15. L

    Wiring issue

    I just rewired my 1946 2N and when I turn the switch on ampmetersmokes,so I reversed the wires and it smokes again and needle pegs both ways. Can someone advise me on this. Tom
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top