(800) 853-2651
SHOP NOW

Recent content by lulu

Yesterday's Tractor Forums
  1. S

    Pushed a little snow

    For the church today and I caught my rain cap on a low branch and bent it . With the help of a good man named Jon I was able to whip it back into shape a little crescent wrench and hammer work fixed it right up
  2. G

    Experimental John Deere Case tractor

    Thought this neat. This tractor was supposedly tested about 60 miles from and up against a 4 wheel drive Wagner TR9. https://greenmagazine.com/the-story-of-the-rtx547/ Experimental JD Case tractor
  3. S

    Front End support

    Well I am putting the front end back onto my 35 and I am thinking there is supposed to be a collar around the pin and shims to keep it from moving back and forth but I dont see them in my manual. Isnt there supposed to be a collar around the pivot pin and some shims there as well. Mine had...
  4. jon f mn

    Water heater solution

    Well, thanks everyone for the great replies. I'm glad so many that actually had one commented. I think I will try one when I need it, but will go with gas because we don't have enough electricity for an electric and we are on nat gas. But for now I was able to fix mine. I'm not usually...
  5. C

    farmall av engine trans stuck

    went to get my AV out its stuck both back wheels lockup,,transmission shifer wont go in any gear,, then got my crank out and engine wont turn over don't know what the heck happened thanks cdv
  6. T

    50-55 series ROPS

    Friend is looking for a good, non rusted out 4 post ROPS for a 4255. One on it came out of Florida and you can guess what the salt water did to it. I know it's a needle in a haystack and I have checked the big national salvage yards. Thought someone here might know of one in a smaller...
  7. T

    AD3 152 injector hold down studs?

    I have another thread going on tractor talk asking about this but I wanted to check here as well. Does anyone know if the holes in the head for the injector studs are supposed to be blind or are they open to coolant? I ask as I have coolant appearing to leak out from the lower stud on the...
  8. D

    1959 International diesel tractor

    On this tractor, there are 3 valves in hands reach? Can someone tell me what control handle operates what as I have to run the right side handle about 1/4 down in order for the middle hydraulics to work on my baler?? Thnks
  9. S

    Massey 510

    What are your thoughts for this combine for small grain? It is a diesel and would use for oats and rye.
  10. P

    Long tractor

    I am searching for a long 510 or 610 crawler does anyone know of one anywhere that is for sale? Please reply or email me at [email protected] thank you
  11. John Deere D

    Re: 255 Massey ferguson AD4-203 exhaust manifold

    e-bay... Massey Ferguson AD4.203 PERKINS DIESEL Exhaust Manifold 37781720 732813M1 50 65 I have connection to this add:
  12. B

    231 ford carb

    have 231 ford starts fine. trouble is it will just die unless I pull the choke all the way. re did the head. good compression. retimed. all new electrical with electronic distributor. new plugs. rebuilt carb. will run alright for a while then tries to die. pull choke and it runs ok with...
  13. W

    Oliver 77 row crop oil filter # napa???

    Anyone on here know the filter number for Napa on the oliver 77 row crop models. I know its a spin on just need a # ?
  14. G

    Bush Hog variation

    What makes a bush hog type trimmer mower different from rough cut, the blades, positioning of mounted wheels, distance from ground, can one convert thier unit from rough cut to finish??? I have also been wondering if without a clutching type extension for the pto / drive shaft for my bush hog...
  15. B

    JD Gator seats

    My seats have come loose from the plastic backing any good suggestions on gooey thick adhesive that will stick the vinyl back to the plastic?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top