-
LLynerd replied to the thread M & W P-400B Dyno.38johndeereG I talked to the fellow who had the Dyno but he has already sold it. Lynn
-
LLynerd replied to the thread M & W P-400B Dyno.38johndeereG Friends and my brother said I should keep it so I am not selling it right now. Used it last week on my brothers Farmall M...
-
LLynerd replied to the thread rustred & used red MN.rustred Squatch is one of a few that I watch and I watch all of his. The D2 was incredible with the amount of work he put into it. The...
-
LLynerd replied to the thread rustred & used red MN.rustred A old fellow who is now 88 years old taught me 34 years ago bead blasting on the 2 cylinder carbs. I watched a video on youtube...
-
LI have been working on some carburetors getting cleaned and put together. One is a M and the other 2 are 400 carbs. One is 50983DC and...
-
-
LLynerd replied to the thread 450 carburetor.used red MN It is not dripping so needle and seat are OK. If I can't get it to idle right tear it back apart and check passages. Lynn
-
LLynerd replied to the thread 450 carburetor.rustred Good point there. Will just take the center drill and put some taper in it. Lynn
-
LHaving got the 450 going that had the broken camshaft gear have been working on the carburetor. Put a kit in the one on the tractor and...
-
-
LLynerd replied to the thread Found the problem.glennster I took the pump off and installed a coupling from a M after modifying the holes. The owner can hook the pump back up when we...
-
LLynerd replied to the thread Found the problem.Janicholson It still would take a lot of force to do that wouldn't it? Lynn
-
LLynerd replied to the thread Found the problem.BarnyardEngineering Proof here. Lynn
-
LLynerd replied to the thread Found the problem.red MN As I told rustred I took pump off till we got it running and with no power steering didn't need it. I don't know much about...
-
LLynerd replied to the thread Found the problem.rustred It didn't have power steering so I put a stock M coupling after modifying the holes to replace pump to keep it from happening...
-
LLynerd replied to the thread Found the problem.Mrfred54 It had the heavy gear in already and the cam rotated freely so must have been in pump. Lynn
-
LLynerd replied to the thread Found the problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy