Recent content by lynn herring

  1. L

    john deere r

    Metro Speedometer rebuilt a 420 tachometer for me & did a good job. I likewise have an hourmeter on my Model R that needs repair. Metro said they could rebuild it also. Another post has already listed their phone # for you.
  2. L

    420 tachometer question

    forgot to include in original post; I've had the tach rebuilt & and trying to get everything rehooked-up to use the rebuilt tach., new cable & drive gear. thanks for the suggestions.
  3. L

    420 tachometer question

    my 420W has an old tach installed in the dash. There is no tach cable and there is a (plug),looks similar to a freeze plug in the block, where the tach drive gear should be. I'm assuming the engine was replaced sometime ago with one that never had a tach installed. Presently trying to restore...
  4. L

    Rickert Implement

    I ordered a carb. kit on 2/5/09 from Rickert. It arrived today (2/11/09). It was an A&I kit for a 420. Maybe I was just lucky
  5. L

    looking for 420 tachometer for 4speed

    addendum to the 420 tach post! forgot to include this is for a 420W. thanks again
  6. L

    looking for 420 tachometer for 4speed

    can't seem to locate a reasonably priced 420 tach for a 1956 420 solid green, 4 spd trans. My apology if this is posted on the wrong forum. Trying to restore this tractor & this is a part I really need. JD dealer says they are no longer available & used ones I have been able to locate are out of...
  7. L

    condenser tester

    Has anyone had any experience with an older condenser tester, brand name "Orbit"? It has a blinking light to indicate if the condenser is good. I recently bought one and it seems work, but I don't know if the test results are reliable or not. Any input appreciated.
  8. L

    jd serial numbers

    My question concerns 2 cyl. John Deere Serial #"s. Were the plates stamped prior to being attached to the tractors or were they stamped after the plate was rivited onto the tractor? I am especially interested in the models made in the late 1930"s and all 1940"s (letter series A,B,D,G & H"s)...
  9. L

    R Pony motor head bolt torque

    I&T manual calls for 20 ft.lbs on the head nuts..
  10. L

    R pony engine-compression

    forgot to add; mine is elec. start, thanks
  11. L

    R pony engine-compression

    Recently bought a '53 model R. Can anyone tell me what the compression should be on the pony engine (cranking eng)?. I did a check and both cylinders show 85-90 lbs. Is this within the ballpark? I do have the JD operator & service manual, but I don't see the compression listed in them. Thanks...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top