Recent content by Lynny

  1. L

    JD 455E crawler injector replacement

    Thanks msm that's what I thought but wasn't sure I put 4 in has new pump cleaned the lines new filter new fuel still wont fire getting fuel to injectors but not thru them
  2. L

    JD 455E crawler injector replacement

    Working on jd 455e injectors out of engine are marked 24188 it is a 4276T engine what number injector do I need to replace them. Cant find anything listed to replace that number thanks for the help.
  3. L

    Brake Job

    It was in there to keep dust and dirt out so not to wear brake shoes depends on what and how much you use the tractor for if used here and there shouldnt hurt.I use mine for landscaping work part time on weekends and havnt had a problem also do bush hogging with it.
  4. L

    Brake Job

    I dont use them when i just did a brake job on my 8N if the brakes are tight without them are you sure you got all the springs on right and the shoes are centered.I didnt have a problem with mine but my drums are pretty wore but for all i use it for i wasnt spendin thr money on new ones.
  5. L

    Replacing front axle bushing - photos attached.

    I had a similar situation on my 165 being that the pin wore clear thru your rear bushing mine did the same.To fix properly i milled rear bushing hole in casting a little bigger and made a oversize bushing on the lathe. If you are looking to just get it back together and your new bushing does not...
  6. L

    12 volt conversion

    Thanks bruce i am going to run points for now i had a guy a local new holland dealer tell me i didnt need the resistor with 12 volt bat and 12 volt sqaure coil glad i asked before eliminating the resistor. He didnt seem to have a clue about the older tractors he just try pushin a new new holland...
  7. L

    D 17 engine block question

    Also where is #1 cylinder starting at radiator end so i can set valves is it 1 2 3 4 from the cylinder closet to the radiator to back of engine.
  8. L

    12 volt conversion

    Yes it is still the sqaure coil now when i buy the kit to convert to ei and go to round coil do i still need it.i will be getting kit from here at yt.
  9. L

    12 volt conversion

    I have a 48 or 49 8N front mount changing over to electronic ignition it is 12 volt now with 12 volt coil. MY question is with 12 volt battery and 12 volt coil do you still need the resistor it has points in it now. just wanting to know if resistor needed with points.
  10. L

    D 17 engine block question

    Thanks kip still tryin to figure out why there is no block serial # behind carb when there is on every other motor ive seen.
  11. L

    D 17 engine block question

    That # is d17-20082 but there is no # on block by carb where i have seen serial # for the engine stamped on other d17 tractors i have looked at.
  12. L

    D 17 engine block question

    There is no serial # on block by the carb tractor serial # is 20082.I am trying to find out if this is a D17 engine. casting # by distributor and power steering pump is AM3853-21 can anyone tell me what i have here by this #.The reason i ask is cause it has a tsx-422 carb on it and these were...
  13. L

    AC D 17 fluid for power director

    Thanks texas allis was wondering where oil fill was for diff. Do you pull the pans off bottom of final drives to drain them and when refilling does fluid flow out the axles to fill finals back up or is there plugs for that also.thanks for the help.
  14. L

    allis HD6 dozer

    Anyone got a HD6 dozer for sale around southwest PA
  15. L

    AC D 17 fluid for power director

    sorry about post read one of the d14 couple post down. my question now is do final drives use same fluid as trans.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top