(800) 853-2651
SHOP NOW

Recent content by M Miller

Yesterday's Tractor Forums
  1. M

    Capri Chest type freezer thermostat ?

    It"s been a long time, but the cap tube runs down one of the walls on the cold side of the insulation. Some of the units had the bulb up against the freezer wall and some had them inside the freezer under a metal protective cover and then some had long cap tube on the cold side of the insulation...
  2. M

    Hand start on Farmall H

    One small thing you forgot to mention on hand cranking. KEEP YOUR THUMB ON THE BACK SIDE OF CRANK HANDLE along with your fingers.
  3. M

    1066 Tachometer has cloudy face

    I use brasso on both glass & plastic takes some elbo grease but works pretty darn good. After you get them clean with the brasso then clean with windex. I have used this on boat windshields scooter wind screens etc, Good Luck
  4. M

    Inherited Farmall - H

    If you are hearin a the starter "clang" it sounds like there is another problem. Chk and see of the engine will turn over by hand. Like stated before pull the starter to see of it's stuck. Then try to turn engine over by hand. Keep us posted on what you find. Good Luck
  5. M

    What is a good backhoe to buy ???

    I spent many hrs on Case 580 machines different sizes. All were 2 wheel drive. If ya get a backhoe stuck the extra 2 drive wheels arn't goin to help. Parts were easy to come by & the Case machines took a pretty good licken. I always liked the way their foot treddles operated. Good Luck with...
  6. M

    MF 220 Backhoe Stabilizer Foot Stuck

    Do you have a air driven muffler chisel? Usually with those air chisel sets ther is a staight point chisel. Take a piece of 1/4 plate, does'ent have to be big in size, 4"X 4" is big enough. Hold the 1/4" plate on the side of the tubing & hammer away with the air gun & straight point on the...
  7. M

    1206 starting

    I have a 3444 that was the same way. fiddled with it for years. Had the starter rebuilt twice but still started the same. Finally found a auto electric shop that new what they were doin. They rebuilt the starter and holy moly no more starting problems. Check the amp draw on the starter when...
  8. M

    Repairing my Radiator

    The reason for using oxy/acetylene and a small tip is for localized heating. Most propane torchs have a wide flame. If you are going to use a propane torch use as small and as fine point tip as you can get. Remember the tubes are very thin & heat up very fast & can be overheated easily. This in...
  9. M

    TD7G starting

    It also may be a weak starter. chk cranking amp draw cold & hot. or chk cranking rpm cold & hot. Also are battery cables good? If you don't have the equip to chk the starter pull it & have a "Good" auto electric shop bench test. They will be able to tell you what is going on. If it chks ok there...
  10. M

    Farmall Super A help

    I would have to agree the others on a stuck starter. Some times they can be a you know what to pull if they have been run a while while engaged. Good luck & keep us posted on what works
  11. M

    The 1755 with gremlins

    Have you checked what the starter is pulling for amps? If you are cranking at too slow a rpm you are not getting injector pressure & I believe it's cylinder temperature. Check the amp draw on the starter when cold & then when hot. I have had problems with starters both ways won't crank when cold...
  12. M

    1968 IH 3444 3 Point

    Is there a way to get the 3 point to have down pressure or am I just you know whaten into the wind. Thk's for the help
  13. M

    Hard Starting 1968 IH 3444 Diesel

    I just want to say thk's to all that gave me info. I chked the the starting rpms they were 285. I chked the starting amps at starter they were 289 amps. YIPs! I chked the starting amps on my Duramax & it was 50 amps. Keep in mind this starter had been rebuilt twice & was always hard to start...
  14. M

    Diesel Engine Starting RPMs

    Thk's, I will chk this weekend to see what the starter is creating for engine RPM
  15. M

    Diesel Engine Starting RPMs

    At what RPM does the starter have to turn over the engine in order to fire.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top