(800) 853-2651
SHOP NOW

Recent content by Mario58187

Yesterday's Tractor Forums
  1. M

    Ferguson TO35- starting issue

    Found the problem today and fixed it. The ammeter had power to one side, but was not flowing current out, disabling the ignition switch. Running like a dream again, thank you folks for the help.
  2. M

    Ferguson TO35- starting issue

    I used a test light to check my connections. The ground is good and power is getting to the solenoid. When I engage the ignition and starter button, no power makes it from the starter button to the solenoid and there is, of course, no power from the solenoid to the starter. The ignition key...
  3. M

    Ferguson TO35- starting issue

    Thank you, gentlemen, I'll give it a shot and I'll post when its fixed.
  4. M

    Ferguson TO35- starting issue

    Good day, folks! I have a 58 TO35, Z134 gas. Last week I went to start it and it cranked for 1/2 second, then nothing. No clicks, no response whatsoever. The next day, it cranked another half second, but then zero response and nothing on the thousand tries since. I've done the following so...
  5. M

    Sputtering/dying fixed

    I bought a TO35 recently and it was running well. I picked up a used bush hog and 20 min later the tractor sputtered and died. Wouldn't start until cold, then died every few minutes. Eventually Wouldn't start at all. Changed plugs, wires, condenser, coil, no fix. Then i changed out the...
  6. M

    To35 metal in oil

    Thank you for taking the time to reply. I'm not sure about repair history, I hope it was already done. I think It sat for quite some time. I'd imagine sooner or later I'll be learning how to rebuild all kinds of old parts, hoping for later. I appreciate the advice, I hope JD Seller is right...
  7. M

    To35 metal in oil

    Thank you for the response! I hope the photos showed up. I'll go ahead with the oil/kerosene and see how it goes from there. Thank you, again.
  8. M

    To35 metal in oil

  9. M

    To35 metal in oil

    I've had this 58 TO35 for about 2 weeks. It has its quirks, one of which I've posted about, but it starts right up every time and runs well. I had to start with the positive. Now to my question. I changed the engine oil recently and found a significant amount of what looked like flakes of...
  10. M

    58 TO35 3 point issue

    Good evening! Thank you for looking. I just bought a 1958 TO35. The 3 point hitch moves slowly up and shudders all the way going up, but is smooth and fast with weight going down. It holds weight on the way up and doesn't creep (at least my 190 lbs). The dipstick behind the right foot is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top