(800) 853-2651
SHOP NOW

Recent content by Mark Bennett

Yesterday's Tractor Forums
  1. M

    TO30 governor problem

    If you have this fully assembled, your are missing some linkage. You need all the vertical linkage and spring.
  2. M

    TO30 governor problem

    Good luck
  3. M

    TO30 governor problem

    Glad to help. Not sure what you mean '"extend fork out to push my carb closed". When you increase the throttle, the governor spring/lever (connected to the carb throttle rod) actually pulls the carb throttle rod forward which opens the carb (to increase rpms). Internally the only governor...
  4. M

    TO30 governor problem

    One thing I noticed between old governor and new one is the old one had a raised area in the center where the lever contacts while the new one is flat. In my opinion, this affects the linkage adjustment and required length. If your tractor over revs, then with the engine turned off, throttle...
  5. M

    TO30 governor problem

    Coupling nut !! to extend rod to carb. Dang phone
  6. M

    TO30 governor problem

    I should have said governor lever in above posts
  7. M

    TO30 governor problem

    The governor itself really doesn't move that much. It's a balancing game between the spring and centrifugal force of spinning the governor
  8. M

    TO30 governor problem

    I couldn't use new cover gasket due. I contacted the vendor. As far as governor, I disconnected my throttle rod from the governor lever, started the engine while I held the throttle rod with my hand. I would move the throttle rod with my hand while watching the governor lever action. Based...
  9. M

    TO30 governor problem

    Btw, did your new gasket fit? Mine didn't
  10. M

    TO30 governor problem

    Did you find the problem? I have the same issue.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top