Recent content by Mark2359

  1. M

    1979 case 580ck power shuttle pump seal keeps blowing

    I replaced the pump with the new rebuild kit.
  2. M

    1979 case 580ck power shuttle pump seal keeps blowing

    Thanks for all the great comments. When I assembled the power shuttle (new rebuild kit) I replaced the internal bushing. It was to tight. I sanded out the bushing until it fit the drive shaft. I believe this was my mistake, should of had it reamed to fit.
  3. M

    1979 case 580ck power shuttle pump seal keeps blowing

    The seal is on the power shuttle pump, between the torque converter and the power shuttle. The pump is part of the power shuttle. That seal keeps blowing out after 10 minutes run in neutral. I rebuild the power shuttle and ran the backhoe for a day. Went to run it the next day, got about...
  4. M

    1979 case 580ck power shuttle pump seal keeps blowing

    My case 1979 case 580 ck keeps blowing power shuttle pump seal. Recent rebuild, checked regulator valve in control valve, replaced 0-rings. Checked relief valve and blew out cooling system, replaced oil. At idle in neutral/4th gear pressure at test port is 100 psi. Dont know why it keeps...
  5. M

    Case power shuttle pump seal

    Thanks, I reposted on case.
  6. M

    Case power shuttle pump seal

    My case 1979 case 580 ck keeps blowing power shuttle pump seal. Recent rebuild, checked regulator valve in control valve, replaced 0-rings. Checked relief valve and blew out cooling system, replaced oil. At idle in neutral/4th gear pressure at test port is 100 psi. Dont know why it keeps blowing...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top