(800) 853-2651
SHOP NOW

Recent content by MARKS87

Yesterday's Tractor Forums
  1. M

    2130 Broken SCV Cover..Cause?- Picture

    Greetings, when using the wood splitter the top cover for the SCV split. It happened when the splitter fully retracted. The tractor was slightly above low idle. I Just put a closed center spool in the energy hydraulics valve and used it for 15 minutes or so when it Busted. Had been using it...
  2. M

    new techecneque for a 4020 turbo set-up

    Hi Tim, are you using nickel rod to weld the manifold or somthing else?
  3. M

    Headlight installation on 4020

    Hi, Di electric grease is an insulator, you might want to run a ground wire. Dielectric grease, or tune-up grease, is a silicone-based grease that repels moisture and protects electrical connections against corrosion. ... The grease does not conduct electricity, so it shouldn't be applied...
  4. RedMF40

    Neat trick with shaving cream

    I bring this up because I recently wanted to read the serial # stamped on side of my new-to-me 9N. Couldn't make it out against the dark metal of the engine block. Here is something that often works: Smear a glob of foamy shaving cream over the stamping. Wipe it off. The cream will embed in...
  5. M

    The 1010 Story

    You should be proud. It's beautiful, and you did it.
  6. H

    John Deere 42 combine

    putting a 205 corn head on to run corn this fall and I had someone tell me I should run filler plates on the cylinder of the 42 just wondering if it will shell corn with out them? Thanks Howard
  7. N

    G. Main case pic in need of repair

    What does everyone think about a fix for this broken ear i have the pcs however it's cracked and almost 2 pcs
  8. M

    Three point hitch won't raise on JD 4020.

    Same thing happened when I changed my load shaft seals too. Took the rockshaft control off to put the follower back on the cam. Problem solved;)
  9. M

    Replacing batteries in 4010 is 2- 6 or 2-12v better?

    I am putting 2 12V strongboxes back in, I was going to check the charging voltage. I am curious to see if the voltage regulator is actually defective or was just abnormally high because of a high load from a bad battery. I don't think it should be over 14.5v regardless of the load. Just want to...
  10. M

    Replacing batteries in 4010 is 2- 6 or 2-12v better?

    Yes, i like warm oil. You live above the tree line don't you?
  11. M

    Replacing batteries in 4010 is 2- 6 or 2-12v better?

  12. M

    Replacing batteries in 4010 is 2- 6 or 2-12v better?

    Hi, I converted the tractor to 12V two years ago with 2-0 cables from each battery to the solenoid. Its starts excellent. Thanks to Tx Jim. The voltage regulator in the 10si alternator is defective and is putting out up to 17.5v which caused the batteries to "boil" the water out. Refilled them...
  13. R

    8N starter questions

    Starter issue with 1951 8N (12v conversion): Last summer the starter would spin but the original Bendix wouldn't engage. I put in a new-style Bendix and the tractor started up fine, but the next day it was the old story -- spin and whir but not engage. I finished the summer by crank-starting it...
  14. M

    One row cultivator ID?

    Hello, does anyone recognize this old cultivator and know the manufacturer? And what the small loops beside where the top link attaches are for. Thanks
  15. F

    8n in a fire

    I am looking for a 8n to put a flathead v8 in. I found one that was in a fire. The tractor did not catch fire but it got hot enough to melt the back tires. My question is do you think the hydraulics will be ok? Any other advise would be good. I know this is hard but what is it worth? Thanks Al
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top