(800) 853-2651
SHOP NOW

Recent content by martin55

Yesterday's Tractor Forums
  1. bumblebee

    fuel pump pressure

    I want to replace the fuel pump on a 6cyl 265 ci Chrysler industrial flat head. Parts guy said that I need to know what the fuel pump pressure is cause he has two pumps and is not sure which is the correct one. Anyone know what the pressure is for this engine? Is it even an issue? Thanks for...
  2. W

    White 2-155 Cummins repower

    So what does it all take to put a 8.3 Cummins in a 2-155 series 2. SAE 2 bell housing White 160 PTO Hub If anybody has done one looking for some details on conversion.
  3. M

    farmall m grunts uphill

    Been a while. Got an M up and running and took it down a hill and up a hill. The uphill seemed to kick the governor in, as the tractor grunted and RPM's increased. Must be hard enough to pull itself up hill, cannot remember that uphills were taxing enough on them.
  4. F

    larry@stines coroner, feature nite

    What about rural paintings or wall hangings.
  5. J

    Dave H, check stanky basaement post

    SWMBO added a reply..
  6. B

    Farmall M Wide Front Value?

    I have this Farmall M / 400 Wide Front I need to sell. Selling out all kinds of things, working on buying a Duramax, and there will be a monthly payment involved, so, I need to get my duckies in a row! ;) You wise guys on here told me this front end was supposed to be on a 400, but would fit...
  7. Y

    D17 Power Director/Pto stick??

    Forgive my utter ignorance on Allis tractors. I've been raised on Massey, Ford, and Farmall tractors. Traded a massey 235 today to a D17 gas with power steering and a loader. The guy I took it on trade from thought the high range was out on it, because moving the tall level by your right...
  8. F

    Massey Harris 333 Engine casting numbers

    I have a 57 Massey Harris 333 that I believe has been re-powered with a different engine. The casting number starts with E400, but I do not know if that number was used on the E208 native to the 333 or if it is a 201 used on the 33. There is also a casting number C 29 T below the number. I...
  9. B

    Massey Harris 745s information or parts

    I'm looking at buying a massey harris 745s tractor, it does need abit of clean up & is missing light's gauges & seat, missing all electrics & non original starter. motor does run & drive. Has 3point linkage. can anybody tell me about this model ? & where I could get parts...
  10. L

    Shimming the steering gearbox

    So, I have my steering gearbox apart. (Ford 640, mechanical steering). When I took it apart, there were a number of shims of varying thickness between the gearbox and the steering column. I assume that this shimming may need to be adjusted for wear? How do I determine the proper amount of...
  11. N

    radiator leak

    My radiator on my 541 is leaking in the front bottom right hand corner from the seat do I need to drain it to fix it? Is it better to try and solder it or try JB Weld?
  12. B

    Best push-button ORC?

    Spent today using my rear bucket to knock down the Killer Knoll(was 'hogging down 8' high grass and hit solid ground that rose up 4' and nearly flipped my 2N over) and I've found that unless I have the top link adjusted to a length that makes for poor scraping with the bucket the lip ends up...
  13. M

    oil filter change

    Have a 1948 TE20 tractor and was going to change the oil and oil filter. Does anyone have a clear picture of the proper assy order inside oil pan. Thanks
  14. M

    TO35 Original Radiator

    I have a 1948 TE20 radiator that leaked and over heated took to radiator repair shop had it cleaned out and and leaks soldered. Works and looks like new cheaper than buying new junk. They don"t use brass like that no more.
  15. M

    OT (battery tender)

    Great products use them on all my toys
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top