-
M
NH 850 round baler gate problems
I was bailing hay today and got about 13 rolls done when I sheared my pto shear bolts. I looked back and my end gate was open. thought I had just forgot to close it good so I went to the shop fixed the shear bolts dumped the partial bail and went back to the field. Bailed 12 a bail and...- MCinKY
- Post #1
- Forum: Implement Alley
-
MS carb parts
Guys, need some main hi speed adjusting needles and seats for the big bowl MS carbs, this is the top mounted adjustment needle with a (appx) 3 in needle with a very fine thread that threads into the carb top. Used would be great if in good condition. Need 3 right now. I will consider core carbs...- mEl
- Post #1
- Forum: Tractor Pulling
-
C
ford 3000 diesel clutch problem
My tractor worked fine a week ago and I went to use it yesterday and NO CLUTCH. Where did it go? Do tractor clutches just stop working with no warning? Any suggestions to check before thinking of a new clutch. Will not go into gear, grinds, pto works.- cd david
- Post #1
- Forum: Tractor & Farm Talk
-
G
Lucas Generator Wiring help needed...
Hello Folks... I am sure someone here can help me.. I am trying to install a Lucas C40 (2 pole) generator and a Lucas 6 pole voltage regulator on a Super major tractor.. This is suppose to be the correct combination and matched set... the problem is that the British Nomenclature is apparently...- Galen ishman
- Post #1
- Forum: Fordson
-
M
24T Baler Implodes, can it be saved?
Thanks guys for all the ideas- This baler was supposedly barn-kept and does look pretty good, considering. Will check into some replacement parts- the swing carriage for the needles seems to be the key part. Needles are available here and there. The plungerhead "dog" was present and attached...- Mary Jane
- Post #1
- Forum: Implement Alley
-
M
24T Baler Implodes, can it be saved?
Bought a used 24T baler a month ago and ran 300+ bales before it decided to implode- it must have gotten out of time (somehow) and the plungerhead snapped the needles, which snapped the knotters, which also bent the needle carriage, the needle carriage pull-bar on the flywheel- etc... Is it...- Mary Jane
- Thread
- Replies: 10
- Forum: Implement Alley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy