-
M
Ford 2000 tractor runs for a while then quits
I will check that. The coil is new as are the plugs, but it may still be an ignition issue. -
M
Ford 2000 tractor runs for a while then quits
Thank you for the reply. There is not a shield on the fuel line. In fact it passes between the exhaust manifold and the engine block. I thought this was a possible cause, but assumed that it was designed that way. Is the shield around the line or somewhere else? -
M
Ford 2000 tractor runs for a while then quits
I have a Ford 2000 4 cylinder that starts really easily and runs smooth for about 30 min and then all the sudden it will sputter out and die. When I try to restart the engine it starts and runs for a second and then dies again. I found that when this happens, I can open the main jet a quarter... -
M
Throttle and governor linkage question
Thank you for the reply and information. I adjusted the linkage according to the Ford manual. Throttle set to high and hold the carb full open. If you can slide the arm on easily, it is correct, in not then adjust. It sounds like this is the same procedure you recommended. The surging...- massild
- Post #4
- Forum: Tractor & Farm Talk
-
M
Throttle and governor linkage question
I have an early Ford 2000 tractor and the Throttle Control Governor Compensating Adjusting Rod (Ford part C0NN9A724A) and the Drag Rod (Ford part C0NN9B786A) are welded together. Can anyone explain why these are 2 separate parts and the function that they provide? I have a surging problem...- massild
- Thread
- Replies: 4
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy