(800) 853-2651
SHOP NOW

Recent content by matt p

Yesterday's Tractor Forums
  1. M

    Need to replace all wiring in MF 202

    The job is not to bad, hardest part is under the dash. My 202 is my work tractor so I did not worry about colour codes I did use 18 ga wire and soldered my ends on. take some pictures for referance the wireing diagram is pretty clear. I also changed my battery cables at the same time. good...
  2. M

    Crankshaft Specs

    I ground down rough keystock to fit mine I had a peace of 3/8 bulk keystock
  3. M

    Drones

    My son who is also in aerospace engineering at Royal military collage of Canada. He bought a drone last year,flies it to find our bloodhounds when they go on their adventures, I can t tell you about his but he has some great video of the land and used it to inspect our brick chiminy
  4. M

    z134 carb

    I got the carb kit ordered from Napa # 2-1401 its a echlin basic kit no throttle or choke shafts.I took the carb apart tonight giving it a good soak. I do have some wear on the throttle shaft I will see how its like with the new parts. The bowl gasket was in real bad shape.float looked good and...
  5. M

    ms 683 carb

    thankyou the carb kit number worked have one on order
  6. M

    ms 683 carb

    oops forgot to say its a Ms tsx 683 thanks
  7. M

    z134 carb

    hi everyone checked the timing and was good,removed the inline filter.still has the hesitation when changing front to back slows down to almost a stall and sometimes does I think I need a carb kit. Can't get one from this site no shipping to Canada. my local Napa did'nt have a number would any...
  8. M

    ms 683 carb

    hi everyone its matt from frozen Canada I need the part number for a marvel shubler carb kit my local Napa store could not find it and this site can't ship to Canada any help would be great thanks. It dropped to minus 22 f last night in southern Alberta
  9. M

    Time to get garden started

    only in my dreams its minus 20f with 3 feet of snow in southern alberta now, good luck I wish I was there.
  10. M

    z134 carb

    I do have rubber fuel line I cleaned fuel bowl seems to have good fuel flow I have a aftermarket inline fuel filter with good flow. I did the tune up thinking it was ignition, had the problem before and after. I didnt check timing after point change,I will start with the timing. its minus 14 f...
  11. M

    z134 carb

    hello everyone I have a mf 202 with the z134. When I am plowing snow changing directions the tractor spudders and stalls unless I feather the clutch I tried adjusting the main jet a little with no difference. Just did new plugs points router cap I think it maybe time for carb rebuild it was done...
  12. M

    Adjusting the Governor on a TO35

    If you check the site archives,its at the top of the page there is many pages on this subject. My massey manual gave me a good starting point then I used john UK to fine tune it once I had it running. Hope this helps.
  13. M

    Transmission Oil / Fluid for MF202 Industrial

    I JUST USE 10/30 MOTOR OIL BUT I LIVE IN CANADA I THINK some guys use universal hydralic tranny fluid I think manual calls for GL1 that you can get at napa My 202 gets used for roto tilling snow plowing and bush hogging its a 1966 with a mf 200 loader and three point lift 540 pto
  14. M

    204 w/ Z134 engine

    you drive them towards the rear of the tractor from the holes the nuts came off of, the bolts come out under the oil pan
  15. M

    204 w/ Z134 engine

    yes remove nuts with two holes front axle pan drive the bolts out with long 1//2 extention or rod then remove the rest of the pan bolts . remember to support the tranny with a jackstand or hydralic jack, block the wheels
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top