(800) 853-2651
SHOP NOW

Recent content by mattwillson

Yesterday's Tractor Forums
  1. M

    super m horsepower

    It'll slip the "will hold 150 hp clutch from hycap" at about half track or so, I'd guess it makes a hundredish or better...would be fun to dyno the ole mare some day.
  2. M

    super m horsepower

    As far as the keystone turbler kit (top shelf kit btw ), if you keep it toned down it can add some economy and power. I have an original C248 with their kit on it , propane head and waste gate deleted(makes 18psi boost). It won't run on pump gas. If you dont screw with the waste gate like I did...
  3. M

    Unwanted contribution - derelict tires

    put a for sale sign in front of the pile, they'll be stolen by morning.
  4. M

    At A Loss With Split Rims...

    I have 4 rims with good tires off of a C50, they're 8.25 - 20 . If that's what you need , you can have them . You will have to come and get them though.
  5. M

    OT Freihgtliner FL-60

    Last 8 of the vin should get you the right ones. Maybe you'll get lucky and the tag is still legible.
  6. M

    More Horsepower

    LP head , adjust waste gate to 15psi boost, 100 octane gas. Only issue would be traction.
  7. M

    Multipower ?

    Run MP low for heavy tillage, High side is over drive through the clutchpack, Low side is gear drive.
  8. M

    VAC keeps killing coils

    You have the coil hooked up backwards
  9. M

    Multiple Tractors and Batteries!!!!!

    We install battery disconnect switches on everything, no more dead batteries and no chance of a fire.
  10. M

    clean oil bath air cleaner

    I soaked the last one in carburetor cleaner for a week, that got it cleaned out.
  11. M

    G148 question

    The bushing shouldn't move in the rod bore. Sounds like the rods are due for service.
  12. M

    NH 273 baler

    Your New Holland dealer will print off the complete manual, usually for free. At least the dealer I deal with did that for me. I did spend a lot of money on parts to get a reliable baler.
  13. M

    model 60 row crop

    If YT or Steiners don't have what you need, I have good used one.
  14. M

    tractor fuel additives

    No snake oils here, Esso supreme (91 octane) goes in everything except the M, It gets a 50/50 mix of supreme and toluene due to c/r and boost.
  15. M

    NEED Best 70's Instant Reverse Mechanic MF40B

    Grease the shaft and confirm springs and linkages are in sync, our 30B can be a pain if it sits too long.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top