-
M
Re: No 8N power revisited
Bob, I used some WD40 and they're now free. actually all the valves look pretty good. I have been using Non-Detergent oil for years. I'm wondering if I shouldn't switch to a detergent one. There is lot of gunk built-up in these old engines. As soon as I get a new gasket I'll zip it back up...- MauNC
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
Re: No 8N power revisited
After extensive ignition troubleshooting, I have eliminated a problem in this area. I spent a considerable amount of not needed time in it, but it was not a waste, simply because I learned a lot and I can now remove the front mount distributor with my eyes closed. As Soundguy pointed out...- MauNC
- Thread
- Replies: 2
- Forum: Ford 9N, 2N & 8N
-
M
No 8N power
I will take the hat off the tractor in the next few days. I use a small lawnmower gas tank that I adapt when the hood is out. At this time I will retake the compression test. (I have to have it off anyway because I need to replace a crankshaft pulley for a later loader installation). Just for...- MauNC
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
No 8N power
Thanks to all you folks for the reply. I will try to expand and answer all your questions. I have a 49' 8N, 12V system w/front mount distributor, electronic ignition, late model governor w/tachometer. Installed new plugs, new plug wires (resistor type to go with the electronic ignition), new...- MauNC
- Post #1
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy