(800) 853-2651
SHOP NOW

Recent content by Mblaxland33

Yesterday's Tractor Forums
  1. M

    TO35 Head Gasket

    It?s dripping in a couple places right at the seam where the head gasket goes. I?m 99% it?s not from the rocker cover. Biggest drop is right over the nameplate on the motor casing
  2. M

    TO35 Head Gasket

    I didn?t replace the head gasket yet, just thought it should be done since its leaking. I could try to torque them to solve the problem I did loosen 3 of the nuts to remove the thermostat cable. Perhaps that?s the problem
  3. M

    TO35 Head Gasket

    Hey all, I have a 57 TO35 with a Z134 that I purchased around Christmas and tore apart and cleaned up. It?s mostly back together and painted. It?s running good but, now that it?s not covered in dirt and grease, I can see more problems haha. So I need to take it back apart to replace the...
  4. M

    TO 35 3pt lift

    Would the pressure relief valve just be releasing because of the weight?
  5. M

    TO 35 3pt lift

    The 3pt would NOT lift it***
  6. M

    TO 35 3pt lift

    Hey all, I put a boom pole on my to35 today to pick up a tractor tire filled with calcium into a pickup. The 3pt would. It lift it, and if I was going to guess the tire weighed about 500-600lbs. I tried raising it all the way with no load and then using a chain fall attached to the boom to...
  7. M

    TO 35 Hydraulic Clean Out?

    Video? https://m.youtube.com/watch?v=PkEAhshHUN8&feature=youtu.be Untitled URL Link
  8. M

    TO 35 Hydraulic Clean Out?

    I?m having a hard time getting the video to upload
  9. M

    TO 35 Hydraulic Clean Out?

    So tonight I ran the tractor for a while to warm it up, and then pulled off the right inspection plate and took this video. So (stupid me) the only reason the 3pt was falling so quick was because the levers weren?t in the right position. So now even if I shut off the tractor it takes a few...
  10. M

    TO 35 Hydraulic Clean Out?

    Oh good call! Wouldn?t want to make any more of a mess than I already have in my garage.
  11. M

    TO 35 Hydraulic Clean Out?

    All, Thank you for all the great responses! So I?ve decided this is my plan. I?ve got some parts coming to do a bit of a tune up and get the motor running well, once those come (hopefully tomorrow) I plan on diagnosing the state of things within the hydraulics cavity as it is currently. Once...
  12. M

    TO 35 Hydraulic Clean Out?

    I do have a shop manual and and owners manual is on the way. Is there anything else I should replace if I?m open it up to clean everything and replace the oil? Pressure relieve valve?
  13. M

    TO 35 Hydraulic Clean Out?

    Hey all, I recently bought a TO35. It?s my first tractor and I?ve been disassembling it, cleaning, and painting it. As I?ve come to the back of the tractor I?ve gotten to the hydraulic system and 3pt hitch. In another thread I questioned the 3pt hitch dropping rapidly (in less than 10...
  14. M

    TO 35 3pt hitch

    I?m in Connecticut. Is it something I can repair or rebuild myself? Or is a new pump needed?
  15. M

    TO 35 3pt hitch

    Would you say it?s worth fixing?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top