Recent content by Merrit

  1. M

    Ferguson T-20 clutch problems

    I got around to use the tractor yesterday. The last time I tried to use it the clutch would not disengage at all, I slammed it in high stood on the clutch and brake , Had to shut it off to stop. I than blocked the pedal and let it set for a few days. Yesterday after blocking the pedal it went in...
  2. M

    Marvel-Schebler carburetor leaking

    This may sound stupid but a couple of good whacks with a small ball peen hammer on the end of a screw driver or on the end of a plug while tension is applied will a lot of the time be enough to break them lose. I use anti seize on all bolts ect.
  3. M

    Ferguson TO-20 Hyd. lift control very hard to move

    Purchased a Ferguson TO-20 and the lift lever is very hard to move, in fact so hard I bent it once. Also on this tractor the Hyd. is either up or down, is there no holding in between ?
  4. M

    Marvel-Schebler carburetor leaking

    As far as the adjustments. The float is set at 9/32 from gasket face to top of float. Idle screw is 7/8 and main is 1 1/4 turns. Warm up and fine tune...
  5. M

    Welding on Fuel Tank.

    I have welded gas tanks. I piped a hose from a running vehicle into the tank to displace the oxygen and vapors. NO problem........
  6. M

    Ferguson T-20 clutch problems

    I bought a Ferguson To-20 1951 a short time back and the problem is the clutch does not want to disengage most of the time. I set the pedal at the 3/16 free travel. At times I have to stand on the clutch pedal and brake to get it to disengage. Any thoughts ?????????
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top