(800) 853-2651
SHOP NOW

Recent content by midmofarmer

Yesterday's Tractor Forums
  1. M

    424 pto problems

    ok ty i'll try that in the mourning should there be a different feel in the pedal as i push it when it goes in between the two stages? how do i adjust the pedal?
  2. M

    424 pto problems

    got a international 424 and trying to run a post auger but i got to shut it off to engage pto it runs fine and i can disengage it while running, does it have to have dual clutch one for drive and one for pto?
  3. M

    belarus 500

    need to figure year from serial number and need new secondary fuel filters
  4. M

    belarus 500

    got a older belarus 500, can't figure out the year? and it's leaking water around the injectors? not for shure if it was drained properly last winter?
  5. M

    international 424 power steering

    researching torque generator idea, got any web links?
  6. M

    international 424 power steering

    mine is like this
  7. M

    international 424 power steering

    like on a 4000 ford ? have a old minneapolis mole that has a chevy truck gear box fitted to it
  8. M

    international 424 power steering

    does that ram sense the steering motion ? part number?
  9. M

    international 424 power steering

    nice idea, would like to keep manual steering intact in case of a power failure
  10. M

    international 424 power steering

    looking to add power steering to my tractor, if i could find power assist would help, maybe power steering off a gleaner combine?
  11. M

    international 424 gotta choke to stay running

    think i got it fixed, pulled plug on float bowl and fuel poured out and then slowed to a drizzle drip, so pulled inlet fitting and screen filter looked good but went ahead and pulled it off and got a gog of stuff blew out, and still gonna leave plastic fuel filter on
  12. M

    international 424 gotta choke to stay running

    i took the fuel line loose and could blow through the filter and make the gas bubble inside the tank easily with gas cap on, it doesn't have a sediment bowl just come straight out of the tank to a rubber line, someone has put a gm 1 wire altenator and aftermarket gauges and the amp gauge...
  13. M

    international 424 gotta choke to stay running

    international 424 gas , starts great and i can drive it all around no problems, but when i start to put it under some load i gotta choke it to keep it running then eventually dies and have to wait a minute to restart, got a regular plastic inline fuel filter and seems to be mostly air, gas tank...
  14. M

    international 424 thread size and type

    would this work Untitled URL Link
  15. M

    international 424 thread size and type

    are all the fittings on this tractor gonna be british? even the flare fittings?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top