(800) 853-2651
SHOP NOW

Recent content by Mike Fox

Yesterday's Tractor Forums
  1. M

    John Deere G Aluminum Radiator

    Yes I had the one piece pedestal to but I took the shaft out from the steering gear down to the spindles and made it lighter all the way through. If you need help let me know it's easy.
  2. M

    John Deere G Aluminum Radiator

    I made the steering shaft that runs vertical through the front ped including lower block that the new spindles were welded to. Hubs were 5-4.5 trailer hubs you can get almost anywhere.
  3. M

    John Deere A compression vs octane

    You might be over doing it a bit on oil pressure. To much oil pressure on a horizontal engine can cause this issue.
  4. M

    John Deere G flat back

    I have one I built years ago, if you have texting available I could send you a pic. Looks and works nice
  5. M

    Air Flow Through Big CI G JD

    Josh, ever find out how many cfm you can get out of a single barrel? I've heard as high as 270
  6. M

    Air Flow Through Big CI G JD

    What RPM are you shooting for? With a big nut G carb your only good up to about 1200.
  7. M

    A little trivia.

    $440 I hope that's close the guy that built my G crank told me how much it was but that was 6 years ago so I added 10%
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top