(800) 853-2651
SHOP NOW

Recent content by Mike (MA)

Yesterday's Tractor Forums
  1. M

    Allis B surge spring

    Both Rod (NH) and DickL have some pretty good photos showing it on their sites (both highly informative photos/folks). Rod's website came up first so the photo link is below: Rod NH s surge spring photo
  2. M

    Allis Chalmers B-12

    I still use my B-112 for blowing snow and a few folks on here keep them as well but the best resource that I know for those tractors is SimpleTractors. They also have/had a decent for sale/wanted section where you could probably get some pricing info. See the link below. Mike Simple Tractors
  3. M

    Allis B three point hitch conversion

    I installed a three point conversion on my C and have found it to be most useful when running with the engine side weights installed. I had good luck with the kit from Jim Danforth at O K tractor. Mike
  4. M

    Ca Hand Clutch removal

    You might want to do a search on the "other allis" board as I believe it was discussion a couple of months ago... the posters handle was DaveinMA
  5. M

    frontend loader

    You might want to search for a Henderson Loader made for the AC B and C. They show up on Ebay regularly and the forum here has a few photos and lots of discussions about them. Mike
  6. M

    Parts for Distributor on Allis G Tractor.

    I"d recommend that you get in touch with Steve at B&B Custom circuits... 77 County Route 519 Newton, New Jersey 07860 Phone: (973) 632-5596. Steve is a great guy to deal with can also help you out with most electrical components at reasonable prices. Mike Custom Circuits
  7. M

    Model B 3pt system

    I picked up a 3 point kit for my C (same kit as your B) from Jim at external_link and have been real happy with it. I looked at the Worksaver and I thought that they were too pricey. Mike 3 Point Hitch Link
  8. M

    Decals for C

    According to Guy Fay"s book (Original Allis Chalmers 1933-1957): - The Allis Chalmers hood decal (black/blue will depend upon the year) should be 4 inches behind the front edge of the hood and 3/4 of an inch above the bead. - The top of the shutter decal was just under the top edge of the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top