(800) 853-2651
SHOP NOW

Recent content by mike11861

Yesterday's Tractor Forums
  1. M

    1600 seat

    Thank you RRLUND! Have a great New Year
  2. M

    1600 seat

    yes those blocks come off but when you put them back in is there a set spacing ?
  3. M

    1600 seat

    I bought new rubbers for the front of my seat on my 1600 How do you screw that adjusting handle in to get the right spacing between the two thoroughly confused! Thanks guys
  4. M

    gas line fitting

    Thanks guys!
  5. M

    gas line fitting

    On my carb on my 1600 oliver there is a brass fitting on the fuel line that has the rubber in it. The rubber is loose or wore out so the line doesn't seal. Where do you get that rubber insert or how do you fix it? thanks
  6. M

    oliver 1600

    I will try it this week!
  7. M

    oliver 1600

    My 1600 seems to run rough after I have been using it. Tried pulling out the choke some but that didn't help. Could it be the ignition system? Still has points, maybe change it to electronic ignition? Changed the fuel filter. Don't know where to start! thanks
  8. M

    88 Oliver transmission

    I have an 88 standard that the shifter will not go into the lower set of gears. It doesn't want to move left or right What do I need to take off to check this out. Figured I would ask before just starting to pull bolts out [finally learning to ask first!] Thanks Mike
  9. M

    chrome exaust

    I will second thurmore got a chrome stack for a cat 35 challenger from him very helpful
  10. M

    1850 mfwd

    I have an 1850 that I might part with My email is good if you want more info thanks mike
  11. M

    1850 oliver injection pump

    thanks I will pull it off in the morning
  12. M

    1850 oliver injection pump

    where is that plate at?
  13. M

    1850 oliver injection pump

    my pump is leaking and I am going to take it off. Any tricks I should know?
  14. M

    case 2290 w/mudhog

    thanks I will try that
  15. M

    case 2290 w/mudhog

    I need help finding a wiring diagram or installation manuel for a mud hog that was put on this tractor in '81 I am hving a little trouble with mine thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top