-
O
McCormick Deering W-6 front engine mount
A Friend Is wanting to remove W-6 front engine cover to replace damaged Cam gear. He said front engine mount has to come off first, two bolts from below will not clear it. Does he need to remove front axle yoke to get these bolt out? any info would be great.- Oldiron29
- Post #1
- Forum: Tractor & Farm Talk
-
M
John Deere 2630 Shifter
Reviving an old 2630, the left-hand range shifter between legs (I, II, & R) is sloppy. I see they added the parking kit, which my tractor has however I found it has the top part of the parking lock kit, but not the correct snap rings. It has the old bushing and snap ring rather than the new...- Mike1208
- Thread
- Replies: 1
- Forum: John Deere
-
M
Ford 3000 carb problems on hill
I believe the function of the accelerator pump in the carb was to solve the issue of the tractors being on hillsides. It def. sounds like float setting - it is probably one of the most important settings on the tractor. Make 100% sure it's right or you end up like me having to take the carb... -
M
Ford 3600 Hydraulic Quadrant Problem
Dumb question, plus I have a 2000, not sure if it is the same on the 3600. But is it in draft control and still does what you say? Or does it do it in position control too? -
M
Lift cover touch control questions
I had a heck of a time with mine. Rebuilt everything minus the pin removal the first time, mine worked better but wasn't right still because of that pin. Took it all apart again (without any assistance or hoist) and disassembled the linkage. Ultimately took it to a machine shop so they could...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy