-
M
Battery disconnect, tractor stalls
That is good information but if I don't need to spend the money I don't want to. The amp meter shows to be neg voltage even on the new battery. I am not sure that he didn't wire it with a negative ground, what do you think? I think that I will check the wiring tonight and report back tomorrow...- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
Battery disconnect, tractor stalls
I just bought it, the generator says 12v on the side, The guy that sold it to me put a disconnect on the battery because his grandpa told him that if it didn't that it would run the battery down. Didn't sound right to me. I believe that you should not have to add anything extra to an existing...- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
Battery disconnect, tractor stalls
so yes, it should stay running ... thanks- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
Battery disconnect, tractor stalls
My N8 has been converted to a 12v system. I have a battery drain situation, so I disconnected the battery while it was running and it stalled. on every other motor that I have worked on, and granted they have all had alternators, the motor should remain running. This one has a generator and I...- mike88
- Thread
- Replies: 11
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
That did cross my mind, I looked it up on YouTube and Wil cut it down as soon as I get it all put back together. Thanks for the heads up- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
Ill look for that. but it popped at the keeper pin just inside the axle case.- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
This is an upgrade from 1 1/8" to 1 3/8" Diameter Shaft. Comes with Bearing. No change of Mounting Holes or Length of Shaft. Ford Tractor Power Take Off ( PTO ) 2N 8N 9N/ Massey Ferguson Tractor TE20 TO20 TO30 WITH PTO CAP & GASKET Ford / New Holland PTO Shaft Conversion Assembly that...- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
New Ford Tractor 9N 8N 2N & Massey TE20 TO20 TO30 PTO Shaft Conversion Kit US $74.99- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
$74.19 on E-bay free shipping, Thanks guys!! broke off right at the case so I could pull the shaft out with my finger tips.- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
PTO stopped
The shaft broke right behind the bearing just inside the rear axel..- mike88
- Post #1
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy