(800) 853-2651
SHOP NOW

Recent content by mike9n

Yesterday's Tractor Forums
  1. M

    12 volt alternator 3 wire to 1 wire

    3 wire alternator went out and found 1 wire local at a good price.
  2. M

    12 volt alternator 3 wire to 1 wire

    Thank you sir. Was hoping it would be simple.
  3. M

    12 volt alternator 3 wire to 1 wire

    41 9n has a 3 wire Delco alternator. I want to install a 1 wire delco alternator. How much rewiring will be required?
  4. M

    Installing new starter drive

    Thanks for the help folks. Got it done with a couple of welders visegrip clamps.
  5. M

    Installing new starter drive

    Thanks Bruce. Haven’t set up shop yet so no access to vise. Got the old drive off with no problem it’s the new one I got from Yesterday’s Tractor that I can’t get the pin back in on.
  6. M

    Installing new starter drive

    Trying to install new starter driver on my 41 9n and the hole on the new drive for the pin is partly covered with the washer. What is the trick to Getting pin in hole?
  7. M

    NLA Plow shares

    Just bought 2 shares from Steve at Ploworx's for my Ferguson 14" double bottom plow. Excellent experience, Steve's very knowledgeable. gave me a total price, sent him a check and he sent my shares. Now if I can find the colter wheel assemblies I'll be set.
  8. M

    plow shares

    Thanks Leroy for the info. I'll check em out.
  9. M

    plow shares

    Looking for shares and complete coltier wheels and mounting hardware for a Ferguson-Sherman 2 bottom plow, NO. 16417, Type 14A. Any help would be greatly appreciated. Thanks, Mike
  10. M

    Ferguson 2 bottom plow

    Yep that looks like it Steve. Guessing it at one time had the colters on it because it still has the 2 chains on it.
  11. M

    Ferguson 2 bottom plow

    Texas just south of Dallas.
  12. M

    Ferguson 2 bottom plow

    Just bought a Ferguson 2 bottom plow and was trying to se if anyone knew where I could get the colters and brackets. The tag on it says Ferguson- Sherman Mfg. Corp. No. 16417, Type: 14A. I'm kinda new to this so was also needing to know what the disc was at the rear of the plow> Thanks for all...
  13. M

    TO35 broke cam

    Yep thinking this might be the way to go. Thanks!!
  14. M

    TO35 broke cam

    Got a 1955 to35 gas engine. Replacing the governor tightening the nut and the end of the cam broke. Anybody have and tricks to replacing the cam without removing the engine?
  15. M

    Front axle support

    Front hole not to bad but back hole is egg shaped pretty bad. Plus many years ago the bolt was welded to the pin and I haven't been able to get the bolt out yet.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top