Recent content by mikegpage

  1. M

    1984 c20 backfiring

    i bought a new check valve for 11 bucks installed it and engine still backfires, i disconnected the hose and no backfire. i think i will loose the pump and plug off holes. no inspection in my state
  2. M

    1984 c20 backfiring

    Wow, I took off the belt from the air pump and "no more backfire" Very Nice Thank you, Should I put in new check valve or take pump off??
  3. M

    1984 c20 backfiring

    Hi, I bougjht a 1984 c20 with 4.1 l6 engine.4 speed manual It starts easy , a little rough while warming up. When driving it backfires through the exhaust almost every time i shift, never backfires other times, new plugs, wires rotor and cap, timing set correctly, valves are all good. previous...
  4. M

    Oil Plug Screen

    thanks for all your help, i ordered a new plug with screen from this site. don"y know if i can go a week without running her though
  5. M

    Oil Plug Screen

    Hi, I bought a 9n last Sept. Oil was real clean so I left it untill now, I used it every other day since I have had it. Runs Great. yesterday I changed oil 10/30,filter ect. when i dropped the plug there was no screen. i felt up inside and still no screen. There also appeard to be no sludge at...
  6. M

    9n hyd oil topping off

    Thank you all, I went to napa and bought a gallon of mineral oil 80/90 GL1
  7. M

    9n hyd oil topping off

    Sorry for the double post, accident
  8. M

    9n hyd oil topping off

    I need to add a small amount of hyd/trans oil, what is in there now i have no idea, but it is very clear and clean, not knowing what it has, what type would be safe to add
  9. M

    9n hyd oil topping off

    I need to add a small amount of hyd/trans oil, what is in there now i have no idea, but it is very clear and clean, not knowing what it has, what type would be safe to add
  10. M

    OT hard starting log splitter

    im using 10 30 mobile 1 synthectic, temps are 0 to 90
  11. M

    OT hard starting log splitter

    no primer bulb, i wish it did, air filter is like new3 it is a paper filter
  12. M

    OT hard starting log splitter

    Yes I choke it for a couple of pulls then with choke off for a couple of pulls, if i leave it choked and keep pulling it floods, the float works properly and the needle valve stops the flow of gas
  13. M

    OT hard starting log splitter

    i have a new log splitter with honda gcv 160la engine. it will start on a couple pulls at 70 degrees, at 50 degrees it takes 7 or 8 pulls, at 30 degrees it takes 30 pulls if it starts at all, below 30 forget about it, Any ideas will be appreciated. is this normal for a log splitter?, would...
  14. M

    gvc 160 honda wont start please help

    Cold out today and it wont even begin to start
  15. M

    gvc 160 honda wont start please help

    hi No popping or kickback, bought seafoam and it runs a little smoother and may start a little better but still a ways to go. i think seafoam helped a little, i gave it a mainline to the carb, kind of like a fogging plus added some to gas tank, will try another dose. thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top