(800) 853-2651
SHOP NOW

Recent content by miller873

Yesterday's Tractor Forums
  1. M

    Massey Ferguson engine ID for water pump replacement

    I think it is like you said, either a AG4.212 or AG4.236. I sent pictures to the Steiner tractor tech people and they are suppose to get back to me first of the week. I have compared pics of the 212 and 236 to this tractor and it looks like it is one of those. Do you know if those two motors use...
  2. M

    Massey Ferguson engine ID for water pump replacement

    I uploaded some pics of the pump and the tractor. Had to reduce them down and not very clear. Hope this helps. Thanks
  3. M

    Massey Ferguson engine ID for water pump replacement

    I hope someone can help me identify my MF tractor. I need to replace the water pump and can't find one. The serial number below the steering wheel is 9A 89634. That seems to indicate a 1970. It is a 4 cyl. gas engine. There is a casting number on the water pump that is 37711073. On the side of...
  4. M

    Old Farm Equipment

    Thank you. I appreciate the help.
  5. M

    Old Farm Equipment

    Can anyone help me identify these pieces of farm equipment and tell me what a reasonable value would be? Thanks This post was edited by miller873 on 03/11/2022 at 09:00 am.
  6. M

    1020 Manual Destroker

    Thinking about your response and want to make it more clear. The starter is cranking very slow due to the pressure from the hydraulic pump and I think that is why to battery cable is getting hot.
  7. M

    1020 Manual Destroker

    Ok, thanks, I will check it over better when I get back home. Thanks.
  8. M

    1020 Manual Destroker

    Will check it when I get back home in about 2 weeks. Battery is new, cables and all wiring new, starter is new. This is a restore project. I do know that if I crank it when there is pump pressure the insulation on the battery cable where it connects to the starter solenoid will start smoking...
  9. M

    1020 Manual Destroker

    /Would a gear reduction starter fix the problem. I know it must have an internal leak but I am not qualified to find it and don't want to spend a lot of money on it. Just want to be able to crank it when it's hot.
  10. M

    1020 Manual Destroker

    I have a 1966 1020 JD gas that sometimes is very hard to crank and won't start when hot. I have installed a manual destroker which takes care of the problem but hydraulic fuel leaks out of the destroker when it is screwed in and tractor starts. Does not leak when screwed out. Any thoughts on...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top