-
M
JD 545 ROund baler problem.
Jim - thanks and thanks. The reset worked fine, but I had the problem with each bale though I hope I fixed it now. With respect to the manuals, thats a little joke by Deere. When you actually try order the manuals online they tell you you can"t. I phoned the 800 number and they got back a day...- Mingy
- Post #1
- Forum: Implement Alley
-
M
JD 545 ROund baler problem.
TX Jim Yes I was having problems with the winder. It was getting stuck and not returning home. After studying the patent and looking at the mechanism, I figured out that: 1) A spring had been replaced, but the replacement is too weak. This was the spring that returns the arm sensor shaft. Due...- Mingy
- Post #1
- Forum: Implement Alley
-
M
JD 545 ROund baler problem.
Thanks everyone - based on the suggestions I was able to reset the twine arm. Unfortunately, the unit doesn't wind properley, but it starts a wind, and thats a start. I'm waiting for Deere to get back to me on literature, but its complicated because this is a European model, however there are...- Mingy
- Post #1
- Forum: Implement Alley
-
M
JD 545 ROund baler problem.
Thanks thats exactly what I was looking for - for some reason I didnt see this until now. It the gate the 'dump' section I control with the tractor hydraulics? Do you know what the 'I'm winding string' signal is? Would you happen to know were the S/N is - Deere has 3 different manual sets...- Mingy
- Post #1
- Forum: Implement Alley
-
M
JD 545 ROund baler problem.
Thanks for the suggestions. The book will take some time to get, and the hay's in the field, but this is my fault for not fixing this last winter. I'm going to order the book online right now. Thanks again- Mingy
- Post #1
- Forum: Implement Alley
-
M
JD 545 ROund baler problem.
Hello everybody and thanks in advance. I spent Saturday and Sunday rebuilidng the yellow thing at the bottom of my JD545. Thats the thing that picks up the hay. If anybody ever needs to know anything about fixing that thing, let me know - I completely disaasembled it, fixed everything...- Mingy
- Thread
- Replies: 16
- Forum: Implement Alley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy