(800) 853-2651
SHOP NOW

Recent content by mjibben

Yesterday's Tractor Forums
  1. M

    550 Cockshutt- clutch removal

    Thank you everyone for your comments, the tractor is split now waiting on parts
  2. M

    550 Cockshutt- clutch removal

    Need to know if there is a pto shaft that needs to be pulled before you pull the engine to do the clutch job
  3. M

    case combine

    case combine on southdakota craigs list northeast
  4. M

    Who makes a tractor style loader bucket?

    Try mds or h and h grand meadow mn
  5. M

    organic corn yields

    Oh my, is this a bean field near Twin Brooks SD, that is still not harvested. Because my brother (whom I have nothing to do with) is a field ACTUALLY 2 FIELDS. That look like this, and he is not organic, He is just to lazy to spray like you should. His neighbors are not pleased at all. We...
  6. M

    Today's funny

    Me , its not me, its the wife that does all the bidding.
  7. M

    Anybody make their

    I have made two of them with electric, motors for inside shop. I used a two stage log splitter pump.
  8. M

    Farmall 240 clutch issue

    I also think clutch plat is stuck try putting in high gear go to wide open throttle and drop clutch hold brakes. I have done this on 4020 jd
  9. M

    400 case diesel wont rev up

    Took cover off like you said played with linkage runs like it should thanks jon
  10. M

    400 case diesel wont rev up

    I do not have the air cleaner hooked up yet, just finished putting in new head gaskets and fuel filters have only a couple hours on them, its been inside for the past 2 months.
  11. M

    400 case diesel wont rev up

    Idles but wont Rev up, was working earlier today
  12. M

    Anyone need 400d engine parts?

    I may need a head will not know until I get this one running. What part of mn do you live.I am in ne sd
  13. M

    4-Her looking for a Oliver Combine 33/35/40 to restore!!!

    I do not know if it is still there was one south of kranzburg sd east side of road just past bemus road been there for years with other oliver stuff
  14. M

    1160 comes home

    it is possible that you have a gasket upside down, or you could have a passageway plugged with rust
  15. M

    800 case 400 trans

    Now I know because the part numbers are not the same they need a 400 clutch, I have not seen the actual tractor but will investigate further. Thank you guys for all your help with my 400 case diesel head gasket, I can not wait to get this tractor up and running and making it purr
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top