-
M
John Deere 3020 gas runs rough under load
The previous owner installed a Pretonix coil. Could that be the problem?- [email protected]
- Post #3
- Forum: John Deere
-
M
John Deere 3020 gas runs rough under load
I have a John Deere 3020 gas that idles well but when under load pulling or running up hill it runs rough. I checked all four cylinders / plugs and they all have good spark. I played with adjusting the governor but made no difference. I also tried adjusting the carburetor but also no change. I...- [email protected]
- Thread
- Replies: 3
- Forum: John Deere
-
M
Ford 861 power master power steering pump
Hello ya'll. I have a Ford 861 power master and my power steering pump is leaking like a sieve. Would anyone know where I could find a replacement pump? All of the pictures I have seen of 861's have the exact same pump. I believe the pump is a Thompson. Any help to point me in the right...- [email protected]
- Thread
- Replies: 4
- Forum: Ford
-
M
Ford 861 power master
Hello ya'll. I have a Ford 861 power master and my power steering pump is leaking like a sieve. Would anyone know where I could find a replacement pump? All of the pictures I have seen of 861's have the exact same pump. I believe the pump is a Thompson. Any help to point me in the right...- [email protected]
- Thread
- Replies: 2
- Forum: Ford
-
M
Ford 861 power master
Hello ya'll. I have a Ford 861 power master and my power steering pump is leaking like a sieve. Would anyone know where I could find a replacement pump? All of the pictures I have seen of 861's have the exact same pump. I believe the pump is a Thompson. Any help to point me in the right...- [email protected]
- Thread
- Replies: 4
- Forum: Restoration Processes
-
M
Ford 861
:D Thank you for the information & the quick response Bob. It does have a sleeve bearing. I will look and attempt to change it out. Especially need the tractor before winter sets in. Thanks again. Chat more later.- [email protected]
- Post #1
- Forum: Restoration Processes
-
M
Ford 861
Power steering Ford 861 Powermaster. Looking for information; My Ford861 power steering pump is a belt driven Thompson products Model P1072. It developed a severe leak usually emptying the reservoir in about 30 minutes. Does anyone have any information on the availability of these pumps or...- [email protected]
- Thread
- Replies: 2
- Forum: Restoration Processes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy