(800) 853-2651
SHOP NOW

Recent content by mkentcomeaux

Yesterday's Tractor Forums
  1. J

    F3 Gleaner Hydro Issues

    I have a 1983 F3 Gleaner combine. While combining the hydro unit became hot enough to start some debris on the hydro unit to smolder. Luckily we were able to extinguish before a fire ensued. Was wondering if anyone has encountered this issue. I have never had issues with the hydro before and I...
  2. D

    John Saeli

    Thank you John Put my new hydraulic pump on my 770 yesterday And I have a new tractor Everything works better than it ever has Thanks again Dugger
  3. Destroked 450

    Re: Ford 5610 3 pt lift Will not Raise

    A number of members use classic on this forum, bumping a post back to the top doesn't work in classic
  4. H

    Farmall M oil pressure

    Hey guys, I picked up a '48 M earlier this summer for doing some odd jobs around the farm. The oil pressure starts out at around 40-50 psi cold then drops down to almost nothing after about 30 mins of use. I've changed oil and filter, tried 15w40 and strait 30w. I pulled the oil pump...
  5. B

    OT - 327 Chevy wrist pin gouges cyl. wall

    Never came across this before, any idea the cause? Then back story is the motor was rebuilt, say as was needed, cylinders just honed, new pistons, forget what was done in the heads, this was late 90s. So that cylinder lost compression. Friends 62 SS impala. In my new shop, we just got the...
  6. S

    JD 2040 Algae in fuel filter, replaced, ran for 5 minutes

    I just purchased this JD 2040 4 weeks ago, it was not used too heavily in recent year by the prior owner. Put a lot of hours brushcutting in the past week, then started having RPM varying when near idle, then cut out. Found that bottom of fuel filter had black tar-looking algae. Replaced fuel...
  7. C

    It's in the bin.

    Corn harvest 2019.....one which we would rather forget. Late getting planted, cold wet spring and hot dry summer. Once we did get some rain, some corn plants restarted resulting in very high moisture, but we did pick up a bit more yield on there plants. Moisture levels on corn I harvested ranged...
  8. B

    Leveling Building Spot

    I'm building a small pole barn and the site that it will set on is slightly unlevel and a bit lumpy. I can hire it leveled, but prefer to do it myself and save the $$$. We don't have front end loaders, backhoes, bulldozers etc. What we do have are tractors, plows, discs, field cultivators...
  9. T

    Old Raked Hay on the field!! Help!!!

    I cut and raked my hay field about a month ago and started baling. After about 20 bales, it started pouring rain for the next two days. Now that my second cutting has grow up, I'm needing help on how to deal with the clumps of windrows on the ground. Do I just rake them up before cutting again...
  10. J

    8N Starter Woe

    Went to start one of the early 8N's today (converted to 12 volt) and when the power was applied there was a brief "clack" and then only the spinning, unengaged sound. I rocked the tractor thinking it might have just stopped on a worn ring gear tooth, but no difference in sound after two or...
  11. B

    Division 5 + plus

    Is a Oliver 77 with a Hercules 465/478 gas a legal tractor/motor combination set up for Division 5 plus 12 mph? Thanks
  12. T

    Auction with shopbuilt tractors

    Not affiliated in any way. I thought the shop built tractors are interesting. Not sure if I will be able to attend unfortunately. https://gannonauctions.com/2018/04/15/
  13. L

    Needle and seat

    On N TSX carbs are the aftmk seats any shorter or longer then the old oem and are the slots for removal and installation of the seat wider or thinner.
  14. S

    Tractor starts but wont keep running

    Farmall 350 ran fine when I drove it home. Went to start it today. It fires right up but will only run for about 20 seconds. But will fire right back up and run for 20 seconds. It has good fuel flow to the carb. It has good spark. It is firing on all cylinders when it starts. No smoke...
  15. S

    Allis d19 duels

    Looking for or options. I want to put axle duels on D19 but need the extentions or off brand axle hubs i can use.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top