(800) 853-2651
SHOP NOW

Recent content by MNBeard

Yesterday's Tractor Forums
  1. M

    Ford 6.2 gasser

    I have a 2012 Ford 3/4 ton with the 6.2.Plenty of power and a 6 speed transmission, gas mileage not great probably because its a 4wd with a 3.83 rear end
  2. M

    Blade Or Bucket For Snow removal

    Dont know where youre located but here on the prairies of SW MN we sometimes get s lot of snow. I have a FWA with a loader on front and a snow blower on back to handle just about any snow we get. A back blade in two to three foot drifts would be a non starter.
  3. M

    Scuffed sanded the rollers with 80g belt sandpaper

    I use paste wax on all my power tool tables
  4. M

    Kubota tractors

    Hello all I have enjoyed this site for many years. I am thinking of trading my McCormick CX95 on a Kubota. Nothing much wrong with the CX except its age,little things are starting to go wrong and Im too old to be crawling under or through a tractor. Im looking at a 2016 M5-111D or a 2018 M5-111...
  5. M

    Snow thrower find

    Lawn chair. Snowblower made short work of it.
  6. M

    Ford filter

    Recently I serviced my little 1600 Ford and needed an oil filter. Surprisingly NAPA didn't have one, so went to a local Ford/New Holland dealer, the only one for miles around I might add. They had one for the price of $20.29! Now that little Ford has a little 25hp 2 cyl Diesel and the filter is...
  7. M

    SOS trans

    I am looking at a Ford 4000 with a SOS tranny. I have read that later tractors with this transmission hold up better than earlier ones. Is there a serial # where you could tell if it has the improved trans ? Or should I just avoid the tractor entirely. I have heard a lot about the SOS tranny...
  8. M

    Rough ride this morning

    Sorry to hear about your troubles. I used to ride motorcycle a lot, quit after 3 close calls with car drivers blowing stop signs and red lights.
  9. M

    Ford live PTO

    What number tractor did Fords start coming with live PTO?
  10. M

    Ford 2600

    I am looking at a Ford 2600.I know this is a small tractor but it will only be used for light duty around the yard, such as sickle mowing and blading. Any info good or bad would be greatly appreciated. Thank you
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top