-
M
JD governor lazy
Been through this governor repeatedly. New bearings, repaired holes in weights, weight radius' smoothed, No binding, different linkage adjustments, shafts, bushing, weights(never anything other than stock). If I unhook the carb linkage and operate by hand the governor seems to operate as it...- Modeere
- Thread
- Replies: 4
- Forum: Tractor Pulling
-
M
MM Z Puller
What's the right carb size for 255 cube side valve engine?- Modeere
- Thread
- Replies: 1
- Forum: Tractor Pulling
-
M
Moline z puller
Thanks for the info. I checked into the manifold that's on it. It's a u302 with a fabbed elbow already. It has an original exhaust manifold for an r. I have a vertical exit coming. I may send the cylinders out for some port work this winter.- Modeere
- Post #1
- Forum: Tractor Pulling
-
M
Moline z puller
Anyone have any intake manifold knowledge of what would work best? Z-lp, 335-lp, or gas 335. Using straight up exhaust and about 250 cube.- Modeere
- Thread
- Replies: 2
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy